3Com OfficeConnect Remote 812 list tunnel Use this command to list the name and status of tunnels

6-8CHAPTER 6: MANUAL SETUP

be blank (assigned with the value “”). You can change the PASSWORD and SEND_PASSWORD using the SET TUNNEL [PASSWORD SEND_PASSWORD] command. You must change the SEND_PASSWORD (to the appropriate authentication password value expected by the VPN Server) using the SET TUNNEL

<tunnel_name> SEND_PASSWORD command. You may optionally change the PASSWORD using the SET TUNNEL < tunnel_name> PASSWORD command.

You must make sure that the tunnel is disabled before you attempt to change the passwords.

Tunnel Commands The commands presented in this section enable you to display tunnel information, enable and disable a tunnel, and set the tunnel parameters shown in Table 6-2.

add tunnel <tunnel_name> Use this command to set up a VPN tunnel with the default values shown Table 6-1.

Optionally, specify the server end point and the remote ip address as follows:

SERVER_END_POINT <HOST_NAME OR IP_ADDR>

Aremote_ip_address value specified as an add tunnel command option should be 255.255.255.255 (this is the default value).

delete tunnel Use this command to delete the tunnel. <tunnel_name>

enable tunnel Use this command to activate the tunnel. <tunnel_name>

disable tunnel Use this command to deactivate the tunnel. <tunnel_name>

list tunnel Use this command to list the name and status of tunnels.

show tunnel Use this command to display the parameter values currently defined for the <tunnel_name> specified tunnel.

set tunnel <tunnel_name> Use this command to modify any of the parameters of the tunnel. The following is

a list of set tunnel parameters and supported values: Table 6-2812 Set Tunnel Parameters and Supported Values

Parameter	Supported Value	Remarks
ENCRYPTION_ALGORITHM	NONE
	AUTO
	MICROSOFT_128BIT
	MICROSOFT_40BIT
	MICROSOFT_56BIT
	REQUIRED
MTU	1400
TUNNEL_TYPE	PPTP, L2TP