CLI Commands B-37

Parameter

Description

 

 

<vc_name>

VC profile name.

 

 

address_

Determines how the IP address will be assigned for remote IP network

selection

connections.

 

NEGOTIATE - learn the remote IP address.

 

SPECIFIED - uses IP address set in remote_IP_address value

 

 

bridging

Enables/disables bridging across this link.

 

 

default_route_

When enabled, a default route is automatically created (by negotiation)

option

with the remote router’s IP address.

 

 

Destination_

For an SVC, this is the destination E.164 address to which a connection

address

will be established.

 

 

End_time

This field is the end time for the virtual circuit. The expected format is

 

HH:MM:SS. The Seconds field is optional.

 

 

Header_

This determines whether you will have no compression on cell headers, or

compression

if you will use TCP/IP compression on the cell headers transmitted across

 

this vc.

 

 

idle_timeout

Interval to wait before timing out an inactive connection. Default: 300

 

seconds.

 

 

input_filter

Designation of the filter file in FLASH memory to be applied to the input

 

data stream.

 

 

ip

Sets interface to enable/disable protocol. Default is enable.

 

 

ip_routing

Sets routing type (RIP packets) accepted on this connection. Options:

 

LISTEN - detects packets destined for system’s nets

 

SEND - routes packets destined for the remote network

 

BOTH - both of the above

 

NONE - ignores all routing packets

 

 

ip_source_

When enabled, any packet who’s source IP address falls within the LANs

validation

IP network will be dropped.

 

 

ipx

This controls whether to enable or disable IPX for the virtual circuit. The

 

choices are [ENABLE, DISABLE].

 

 

ipx_address

This sets the IPX address for the virtual circuit.

 

 

ipx_routing

This sets the routing type (RIP packets) accepted on this connection.

 

Options are:

 

ALL - listens, sends, and responds RIP packets.

 

LISTEN - detects packets destined for the system’s network.

 

NONE - ignores all routing packets.

 

RESPOND - responds by sending out packets

 

SEND - routes packets destined for the remote network.

 

 

ipx_wan

This determines if IPX is enabled or disabled for the WAN. Options are

 

[ENABLED, DISABLED].

 

 

local_IP_address

IP address of the VC making an IP connection over the WAN interface.

 

There are two special values which may be assigned to the

 

local_IP_address:

 

The local_IP_address should be learned via PPP negotiation

 

(255.255.255.255).

 

The interface is Unnumbered (0.0.0.0).

 

 

mac_routing

Determines if MAC-Encapsulated Routing is enabled.

Page 139
Image 139
3Com OfficeConnect Remote 812 manual ENABLED, Disabled