3Com OfficeConnect Remote 812 Hangup, interfacename, using list network services, tunnelname

B-16APPENDIX B: CLI COMMAND DESCRIPTION

enable link_traps This command tells SNMP to send linkup and linkdown traps for the specified interface interface. You can see if the interface is currently enabled for traps using the show

<interface_name> interface settings command.

enable network service Enables the network service that you previously defined with the add network <service _name> service command. You can see which services are currently defined and their state

using list network services.

enable security_option Enables CLI access to remote TELNET and dial-in users. This prevents remote users remote_user from modifying the configuration. CLI configuration can be done from the console

administration port and remote users. You can use disable security_option remote_user administration to restrict CLI access to the console port only and enable security_option remote_user administration to re-open full TELNET access.

enable security_option Enables SNMP access to the user table. This allows remote users to use SNMP to

snmp user_access update the user table, and gain unauthorized access to the CLI. Use show

security_options to see the current security values.

enable snmp This command tells SNMP to send traps for both local and remote authentication. authentication traps You can use show snmp to see the current setting.

enable tunnel Enables the specified tunnel.

<tunnel_name>

enable telnet escape If the TELNET escape character was disabled by the disable TELNET escape command, this command re-enables it. When enabled, TELNET client users who press the TELNET escape key during their session will get a TELNET command line.

By default the escape character is control-]. A TELNET user can change it using set escape in the TELNET program.

enable user <user Enables a user to establish TELNET sessions for remote management. You must name> have previously added the user using the add user command, where enabled is the

default. The list users command displays a summary of all configured user profiles.

enable vc <vc name> Enables a virtual channel to establish data sessions over the WAN. You must have previously added the VC using the add vc command, where disabled is the default. The list vc command displays a summary of all configured VC profiles.

exit CLI If CLI password protection is enabled, this command forces an immediate logout from the CLI. The CLI password must be entered in order to access the CLI again.

HANGUP

hangup interface Causes the connection on the specified interface to hangup (drop).

<interface_name>