3Com OfficeConnect Remote 812 manual 4APPENDIX a Officeconnect Remote 812 Sample Configuration

A-4APPENDIX A: OFFICECONNECT REMOTE 812 SAMPLE CONFIGURATION

dynamically learn the addresses for two remote DNS Servers. The login name for this account is “internet-user” and the password is “1a2b3c”.

Port Address Translation will be enabled, allowing all the workstations on our local LAN to share one public IP address. This Remote Site will be used as our default gateway. The ATM virtual channel is VPI 0 and VCI 32 and the Peak Cell Rate is set to the default access rate.

This remote site is configured with the following commands:

add vc Internet

set vc Internet ip enable ipx disable bridging disable set vc Internet network_service ppp

set vc Internet send_name internet-usersend_password 1a2b3c

set vc Internet atm vpi 0 vci 32 category_of_service unspecified pcr 0 set vc Internet address_selection negotiate

set vc Internet local_ip_address 255.255.255.255 set vc Internet nat enable

set vc Internet ip_routing listen

set vc Internet default_route_option enable

enable vc Internet

Remote Site: Corporate In this section, the Remote Site to the Corporate office is defined with the Access identifying name of “corp-net”. IP and IPX are both routed over this remote site

and all other protocols are bridged. The configured network service is RFC 1483 and the remote router address is specified (192.168.1.254). The WAN IPX interface is Unnumbered.

Port Address Translation is disabled on this Remote Site Profile. The ATM virtual channel is VPI 0 and VCI 33 and the Peak Cell Rate is set to the default access rate. This remote site is configured with the following commands:

add vc corp-net

set vc corp-net ip enable ipx enable bridging enable set vc corp-net network_service rfc_1483

set vc corp-netatm vpi 0 vci 33 category_of_service unspecified pcr 0 set vc corp-netremote_ip_address 192.168.1.254

set vc corp-netlocal_ip_address 0.0.0.0 set vc corp-netnat_option disable