3Com OfficeConnect Remote 812 If Name - eth1, DA1 or loopback, Interface - eth1, DA1 or loopback

CLI Commands B-19

list interfaces Displays the installed interfaces, along with their operational status, administration status, and interface index. If an interface is down, you can use enable interface to try to bring it up. The command lists:

Index - number used to identify the interfaces position in the table

Name - interface name: eth:1, DA:1 or loopback

Oper Status - current, operating status of interface; UP or DOWN

￿Admin Status - administrative status you designated interface to be, up or down. If it doesn’t match Oper Status, a problem exists with the interface.

list ip addresses Displays the IP address for each interface. It lists:

Address - IP address of the interface

Bcast Algo - broadcast algorithm used

Reassembly Max Size - maximum allowable size of packet that can be

￿reassembled from a fragmented packet

Interface - interface this IP address uses to connect to the system

list ip arp Displays the contents of the ARP cache. It lists:

IP Address - IP address for this entry

Phys Address - MAC address that the IP address maps to

Type - interface type: Ethernet or Token Ring

￿If Name - eth:1, DA:1 or loopback

list ip interface_block Displays the IP addresses associated with each system interface. If the interface has a point-to-point connection, then the neighbor field contains the address of the remote system. This command lists:

Address - IP address of the interface

Neighbor - IP address of the remote system

Status - status of the connection; ENABLED or DISABLED

￿Interface - eth:1, DA:1 or loopback

list ip networks Displays all the IP networks you previously defined using the add ip network command. It also lists:

Name - network designation

Prot - always the IP protocol

Int - name of the interface this network runs on

State - state of the network; ENABLED or DISABLED

Type - STATIC or DYNAMIC network

￿Network Address - address of the IP network

list ip routes Displays all the statically defined IP routes that you previously defined using the add ip route command. It lists:

Destination - IP address that the route resolves to