3Com OfficeConnect Remote 812 manual Enable

CLI Commands B-15

ENABLE

enable access Enables the Access List feature. When enables, only Remote Hosts in the access list are permitted access to the Router’s management services.

enable bridge network Enables bridging over the specified network. You must have previously run <network_name> add bridge network to add bridging over this network. bridge networking is

enabled by default, so you will only need to use this command if you have previously disabled this bridge. Note that bridging will not occur for a protocol, if routing is enabled for that protocol.

enable bridge Enables the spanning tree algorithm for the bridge connection. The spanning tree spanning_tree algorithm is required if there is more than one bridge between the same two LAN

segments. You can use list bridge forwarding to see which bridges are defined, and show bridge network <network_name> settings to see which options are enabled on a particular bridge network.

enable command Enables the console password feature. When enabled, the user must login with password <password> the specified password before using the console port. This password is not the

same password specified for Remote Login access. Once enabled, the unit must be sent back to the factory if the password is forgotten.

enable interface Enables the specified interface. Enabling an interface enables it to transmit and <interface_name> receive data. You can use list interfaces to see which interfaces are defined, and

whether they are currently disabled.

enable ip forwarding Enables all IP networks to forward (route) packets. You should only need to use this command if you previously used disable ip forwarding.

enable ip network Enables the specified IP network, which you previously defined using add ip <network_name> network. You can use list ip networks to see the currently defined IP networks, as

well as their current status.

enable ip rip Enables the RIP protocol for all IP networks. RIP protocol is set to NONE by default. You can check the RIP version using show ip network settings, and modify it using set ip network. RIP is enabled by default.

enable ip routing Enables all routing protocols for all IP networks. Currently, the only IP routing protocol this command enables is RIP, so it is functionally the same as enable ip rip.

enable ipx network Enables the specified IPX network, which you previously defined using the add ipx <network_name> network command. You can list currently defined IPX networks using list ipx

networks.

enable lan access When the access list feature is enabled, this command enables access to all hosts on the local LAN interface. When enabled, all frames received on the LAN interface bypass the access list check.