3Com OfficeConnect Remote 812 manual CLI Command Description, CLI Commands, add bridge network

B

CLI Command Description

CLI Commands

ADD Use the ADD command to define:

Networks you will connect to

Hosts you need to access

SNMP communities

￿Users who will dial out, dial in, access the network, or use the CLI Note that some parameters have default values.

add access	The access list defines which Remote IP Subnets are allowed access to the
<ip subnet address>	Management services of the OCR812. Use this command to add an entry to the
	list.
	Parameter		Description
	ip subnet address		IP address in the xx.xx.xx.xx/mask format.
add auto_filter
	Automatically adds and enables a blocking destination subnet address on the
eth_blk_dst	Ethernet interface.
	Address - IP address of the subnet to be blocked.
	￿Mask - IP netmask of the subnet to be blocked.
add auto_filter	Automatically adds and enables an input filter on the specified VC. The filter DP
vc_blk_netbios	ports 137 and 138, and TCP ports 139 and 143.
	VC - Specified VC profile name.
add bridge network	{ enabled [yes] }
<network_name>	￿
	Defines a bridge network connection, so your LAN users can bridge to other LANs
	across the WAN. bridging is supported over the WAN.
	Note that routing takes precedence over bridging, so that bridging will not occur
	unless you disable routing for the protocols you wish to bridge. The protocols to
	bridge, and other important parameters, are specified in the user you use to
	establish￿	this connection.