3Com OfficeConnect Remote 812 manual Ipaddress request is sent to the remote DNS Name Server

B-2APPENDIX B: CLI COMMAND DESCRIPTION

You must use add user to create a network type user for this command, and set user to specify the protocol and other parameters related to bridging.

Parameter	Description
<network_name>	Designation you wish to give to this bridge network.
enabled	Default is to enable the bridge network.

add dns host Adds the named host to the Local Host Table. When the system needs to resolve <host_name> address an address for an IP host name, the Local Host table is checked first, before a

<ip_address> request is sent to the remote DNS Name Server.

The add login_host command may also add to this table. See that command’s description for details.

Parameter	Description
<host_name>	Designation of the local host.
<ip_address>	IP address of a named host in nnn.nnn.nnn.nnn format.

add dns server <domain_name>

primary_address [ip_address]

secondary_address [ip_address]

￿vc_name [vc_name]

Adds the IP address of a remote DNS Server for the specified Domain Name to the Domain Name Server Table. The first specified server is sent the IP host name to be resolved, first without, and then with the default domain name (see set dns for more information about the default domain name). If that server cannot resolve the name, it is sent to the next specified server. If PPP is being used for a wide area connection, the vc_name parameter to specify a remote connection from which the primary and secondary addresses will be learned.

Parameter	Description
<domain_name>	Domain name. Use * for all domains.
Status	The status concerning the DNS server.
primary_address	The primary IP address of the DNS server.
secondary_address	The secondary IP address of the DNS server.
vc_name	The VC profile to use for obtaining the DNS addresses

add filter Adds a filter file name to the filter table. The filter table is a managed list of filter <filter_name> names used by SNMP. A filter file is a text file stored in the FLASH file system, that

you load using TFTP. Add filter also verifies the syntax of the filter file.

If syntax verification fails, you’ll receive an error message, and the filter will still be added to the table, but is not usable.