3Com OfficeConnect Remote 812 manual Set bridge Agingtime seconds Forwarddelay seconds

B-24APPENDIX B: CLI COMMAND DESCRIPTION

SAVE

save all Saves all changes you have made during your session with the CLI. It is a good idea to save your changes frequently, just as you should with any type of editor.

SET

set adsl reset Resets the ADSL interface.

set adsl wire [pair] Overrides the auto-direction of inner and outer pair wiring on the RJ-11 connector.

inner - inner pair. outer - outer pair.

set bridge	aging_time <seconds>
	forward_delay <seconds>
￿	spanning_tree_priority <seconds>

Sets parameters for all bridge networks.

Parameter	Description
aging_time	Interval to wait before aging out MAC addresses that were learned from
	other LAN segments. The default is 300.
forward_delay	Interval bridge waits before bridging packets. This time is useful for the
	bridge to listen to packets, look at the MAC addresses, and build its known
	MAC address table. Default is 15 seconds.
spanning_tree_	Priority number determines who will be seen as the “root” bridge in a bridge
priority	network. The default is 32768.

set bridge firewall Sets the mode of the Bridge Firewall function. The three modes are completely [firewall_mode] described in Chapter 6.

discard_routed_protocols - packets for routed protocols are not bridged.

fwd_unicast_packets_only - unicast packets for routed protocols may also

￿be bridged. Broadcast and multicast packets are not bridged.

fwd_bc_and_unicast - broadcast, multicast and unicast packets for routed protocols may also be bridged.

set command history <numerical range>

idle timeout <minutes>

local_prompt <string>

￿prompt <string>

Sets console parameters for CLI commands.

Parameter	Description
history	Sets the depth of the buffer holding the command history. Use the
<numerical range>	history command to see the current depth and a list of your last CLI
	commands. The default is 10 commands. The range is 1-500.