3Com OfficeConnect Remote 812 Enabling IPX Routing Configuring IPX for the LAN, Manual Setup

set vc <vc name>

ipx_address <ipx network address>

To specify that the WAN IPX network address should be learned via PPP you can enter FFFFFFFF for the <ipx network address> parameter:

set vc <vc name> ipx_address FFFFFFFF

￿￿

To specify the WAN IPX address using up to 8 hexadecimal characters, use the command:

set vc <vc name>

ipx [DISABLE ENABLE]

The WAN IPX network information consists of the IPX network address for the wide area connection. The IPX network address associated with the WAN connection can be specified by you, learned from the remote site (if you are using PPP as the Network Service for the connection), or the interface can be Unnumbered.

To enable or disable IPX routing in a VC profile use the command:

You must enter the WAN IPX network information

You must enable IPX routing in the profile

delete ipx network <network name>

You can delete a disabled network using the command:

disable ipx network <network name>

￿￿In order to enable IPX to be routed to a remote site, you must configure the following items in the VC profile associated with the remote site connection.

￿

By default, the network is enabled when it is created. You can disable the network using the following command:

You can obtain a list of all configured networks using the command list networks. To only list IPX networks, use list ipx networks.

SNAP]

add ipx network <network name> address <ipx network address> frame [DSAP ETHERNET_II NOVELL

Remember to save your configuration using the save all command before rebooting your OCR 812 so that your changes will be written to permanent FLASH memory.

Unlike IP, there is no setting on the OCR 812 that enables or disables IPX routing functionality on a global basis.

To configure IPX over the LAN you need to assign an IPX network to the LAN port with the add ipx network command. Each network has a name. You will use the name when entering commands related to the network.

6-32CHAPTER 6: MANUAL SETUP

Enabling IPX Routing

Configuring IPX for the

LAN

Configuring IPX for Remote Site Connections