3Com OfficeConnect Remote 812 manual set vc vc name networkservice ppp

enable vc Internet

set vc Internet send_password testpassword

disable vc Internet

For example, if you want to change the PPP authentication password to testpassword for a profile called Internet you would do the following:

Remote Site Management

6-3

Configuring Network Service Information

￿A Network Service defines the data encapsulation and protocol characteristics for the connection between the OCR 812 and the remote site. The OCR 812 supports four types of Network Services: PPP, PPPoE, PPPoA, and RFC 1483. The OCR 812 and the remote site must both use the same Network Service in order for a connection to established and maintained.

Built-in client support for PPPoE and PPPoA in the OCR 812 enables users to take advantage of PPPoE and PPPoA authentication (both of which are widely used by Internet Service Providers) without having to make complex software changes to their PCs.

For PPP, PPPoE, and PPPoA network services, an authentication name and a password must be provided to establish the connection (note that the OCR 812 supports CHAP, MSCHAPv1, MSCHAPv2, and PAP authentication).

MPPE (Microsoft Point-to-Point Encryption) does not support MSCHAPv2 authentication. To use MPPE, you must set your system to use MSCHAPv1. If you want to use MPPE but cannot select MSCHAPv1, we suggest you set encryption to NONE (otherwise, it may be impossible to connect to sites that require some type of encryption).

To set up a profile for PPP, use the following commands:

￿set vc <vc name> network_service ppp

set vc <vc name> send_name <authentication name >

set vc <vc name> send_password <authentication password> To set up a profile for PPPoE, use the following commands

￿set vc <vc name> network_service pppoe

set vc <vc name> send_name <authentication name >

set vc <vc name> send_password <authentication password> To set up a profile for PPPoA, use the following commands:

￿set vc <vc name> network_service pppoa

set vc <vc name> send_name <authentication name >

set vc <vc name> send_password <authentication password>

To set up a profile for RFC 1483 (which does not support authentication),

￿configure the Network Service using the command: set vc <vc name> network_service rfc_1483