Cisco Systems 5.2.x manual Configure Emulator Settings in Cast, Choose Cast Remote Control, 15-7

Chapter 15 DMP Remote Control and Its Emulation

Procedures

What to Do Next

•Proceed to the “Configure Emulator Settings in Cast” section on page 15-7.

Related Topics

•Enable IP Phone Autoregistration, page 15-5

Configure Emulator Settings in Cast

Note Options on the Remote Control page might sometimes be dimmed and not available to you.

•Click Save to activate dimmed options if this occurs during Step 1.

•This occurs during Step 2 only when your choice is None. Choose either All DMPs or Selected DMPs to reactivate options that your choice dimmed.

Before You Begin

Complete the workflow in Cisco Unified Communications Manager to provision the emulator to your IP phones.

Procedure

Step 1 Choose Cast > Remote Control.

Step 2 Choose an option from the Display Security PIN on screen list, to set how many of your DMPs should support the emulator.

•All DMPs

•Selected DMPs

•None

Step 3 (As Needed) Did you choose Selected DMPs in Step 2?

If so, click Display DMP Selections to refine your list of which DMPs should support the emulator.

a.Use check boxes to select and deselect DMPs.

b.Click Save Selection Changes to save your work.

c.Click Close to dismiss the dialog box.

Step 4 Choose an option from the Security PIN behavior list.

Although Cisco Cast randomly generates all of its emulator PINs, the fixed and dynamic types differ in their persistence.

•Fixed — These PINs persist until the PIN management type is changed.

•Dynamic — These PINs expire and are then regenerated after an update interval that you define. No two DMPs in your network will use the same PIN at any one time.

	User Guide for Cisco Digital Media Manager 5.2.x
OL-15762-03		15-7