Chapter 15 DMP Remote Control and Its Emulation

Procedures

Start the Emulator on a Mobile Phone

Before You Begin

Configure emulator settings in Cisco Cast.

Make note of the generated PIN code in the top-right corner of a DMP display that is showing Cisco Cast. The emulator cannot control the corresponding DMP without this PIN.

This procedure assumes that you are using a supported platform. To learn which mobile phone platforms we support in this release, see our release notes on Cisco.com. An unsupported platform might not be capable of running the emulator.

Procedure

Step 1 Start the Internet browser on your mobile phone.

Step 2 Go to the URL that you see on the DMP display that is showing Cisco Cast.

You are prompted to enter the PIN.

Step 3 Enter the PIN, and then click Go.

The emulator starts.

Step 4 Stop. You have completed this procedure.

Related Topics

Configure Emulator Settings in Cast, page 15-7

Use the Emulator on an IP Phone or a Mobile Phone, page 15-10

Use the Emulator on an IP Phone or a Mobile Phone

Before You Begin

(If you will use the emulator on an IP phone) Complete the workflow in Cisco Unified Communications Manager to provision the emulator to your IP phones.

Configure emulator settings in Cisco Cast.

Start the emulator on your phone.

Procedure

Step 1 Consult DMP remote control documentation on Cisco.com and pay particular attention to sections that describe button behaviors. These descriptions apply equally to the physical unit and its emulator.

 

 

 

Note

The emulator has fewer buttons than the physical remote control has. You cannot invoke behaviors from the

 

 

emulator which correspond to any buttons that it does not have.

 

 

 

Step 2 Stop. You have completed this procedure.

 

User Guide for Cisco Digital Media Manager 5.2.x

15-10

OL-15762-03

Page 214
Image 214
Cisco Systems 5.2.x manual Start the Emulator on a Mobile Phone, Use the Emulator on an IP Phone or a Mobile Phone, 15-10