Cisco Systems 5.2.x Start the Emulator on an IP Phone, Go to Alternate TFTP, and then press Yes

Chapter 15 DMP Remote Control and Its Emulation

		Procedures
Step 3	Go to Network Configuration, and then press Select.
Step 4	Go to Alternate TFTP, and then press Yes.
	Tip	If Alternate TFTP is not an option in the Network Configuration menu, contact the administrator for Cisco
		Unified Communications Manager.
Step 5	Click Save.
	The IP phone is restarted automatically, so that its configuration changes can take effect.
Step 6	Stop. You have completed this procedure.

Related Topics

•Workflow to Provision Emulator Service for IP Phones, page 15-2

•Use the Emulator on an IP Phone or a Mobile Phone, page 15-10

Start the Emulator on an IP Phone

Before You Begin

•Provision the emulator for use on Cisco IP phones.

•Configure emulator settings in Cisco Cast.

•Configure your IP phone to emulate the remote control.

•Make note of the generated PIN code in the top-right corner of a DMP display that is showing Cisco Cast. The emulator cannot control the corresponding DMP without this PIN.

Procedure

Step 1 Press Services on your Cisco IP phone.

Step 2 Highlight the remote control option in the services list, and then press Select.

Step 3 Tap the PIN field on your touchscreen.

Step 4 Use the keypad to enter the PIN code.

Step 5 Tap Submit on the touchscreen.

The touchscreen is refreshed and the emulator starts.

Step 6 Stop. You have completed this procedure.

Related Topics

•Workflow to Provision Emulator Service for IP Phones, page 15-2

•Configure Emulator Settings in Cast, page 15-7

•Use the Emulator on an IP Phone or a Mobile Phone, page 15-10

	User Guide for Cisco Digital Media Manager 5.2.x
OL-15762-03		15-9