10-4
UserGuide for Cisc o Digital Media Manager 5.2.x
OL-15762-03
Chapter10 DMP Dash board
Concepts
Figure 10-2 The Digital Media Players Gauge
Tip DMM might report temporarily that a newly added DMP is unreachable. Most commonly, this occurs before the first polling
session. The interval between DMP polling cycles is 5 minutes. In this case, wait a few minutes, and then check again.
Note Configure your DHCP servers to expire leased IP addresses for DMPs only when DMPs are restarted. A registered DMP
might become unavailable for centralized management if it receives a new dynamic IP address from the DHCP server at its
deployment site. In this case, you should restart the DMP or edit the IP address record that DMM maintains for the DMP.
Related Topics
•Understand the Media and Schedules Gauge, page 10-2
•Use the Cast Gauge, page 10-8
•Use the Settings Gauge, page 10-8
Understand the Cast Gauge
The Cast gauge shows whether Cisco Cast is configured and tells you whether the most recent
synchronization succeeded with your preferred EPG provider.
Figure 10-3 The Cast Gauge
Related Topics
•Understand the Media and Schedules Gauge, page 10-2
•Use the Digital Media Players Gauge, page 10-8
•Use the Settings Gauge, page 10-8