Cisco Systems 5.2.x manual Activate or Deactivate Hdmi Autodetection, 14-14

Chapter 14 Touchscreens, Projectors, and Displays

Procedures

When you use an HDMI cable or a DVI cable to connect your DMP to a 40- or 52-inch Cisco LCD display, you can use Digital Signs to centrally manage the LCD display.

When unmodified HDMI is the connection type from a DMP to either of these display models, centralized management from DMM works immediately, without any prerequisites. However, when you combine HDMI with a DVI adapter, you must complete a simple task at the physical installation site for your display before you can start to centrally manage it.

Before You Begin

•Activate RS-232 command access for your 40-inch or 52-inch display.

Procedure

Step 1 Press Menu on the remote control for your 40-inch or 52-inch LCD display.

OR

Press Menu on the LCD display front panel.

Step 2 Choose Input > Source List > DVI, and then press Enter.

Step 3 Choose Input > Edit Name > DVI > HD STB, and then press Enter.

Step 4 Stop. You have completed this procedure.

Related Topics

•Elements to Activate RS-232 for Supported LCD Display Brands (except DMTech), page 14-28

•RS-232 Command Reference for Cisco LCD Displays, page 14-29

•Configure and Manage Equipment, page 14-15

Activate or Deactivate HDMI Autodetection

Procedure

Step 1 Deploy the System Task event called HDMI Display Autotection On.

OR

Deploy the System Task event called HDMI Display Autodetection Off.

Step 2 Stop. You have completed this procedure.

Related Topics

•Elements to Control HDMI Display Autodetection, page 14-27

	User Guide for Cisco Digital Media Manager 5.2.x
14-14	OL-15762-03