Cisco Systems 5.2.x manual Configure an IP Phone to Emulate the Remote Control, 15-8

Chapter 15 DMP Remote Control and Its Emulation

Procedures

Step 5 (As Needed) Did you choose the dynamic PIN type in Step 4?

If so, enter at least one digit in the Security PIN update interval (minutes) field.

The interval cannot be any less than 2 min. When you do not enter any value, Cisco Cast uses its factory-default interval of 5 min.

Step 6	Enter a shortened URL in the Access URL field for a page that will redirect ultimately to
	http://<DMM_hostname>:8080/etv-remotecontrol-webapp/app/index.htm.
	Note	The shortened URL must not be more than 24 characters long.

Step 7 Click Save.

OR

Click Cancel to discard your selections and start over again.

Step 8 Deploy the new emulator settings to your DMPs.

a.Choose Digital Media Players > DMP Manager.

b.Choose the DMP or DMP group that should use these settings.

c.Choose Cast from the Actions list, and then click Go.

Step 9 Stop. You have completed this procedure.

Related Topics

•Workflow to Provision Emulator Service for IP Phones, page 15-2

•Configure an IP Phone to Emulate the Remote Control, page 15-8

•Start the Emulator on an IP Phone, page 15-9

•Start the Emulator on a Mobile Phone, page 15-10

•Use the Emulator on an IP Phone or a Mobile Phone, page 15-10

Configure an IP Phone to Emulate the Remote Control

You can configure a Cisco IP Phone from the 7960 series or the 7970 series to emulate the remote control for Cisco Cast, and then use keys drawn on its touchscreen to choose options from the electronic program guide, change channels, and adjust audio volume levels.

Before You Begin

Complete the workflow in Cisco Unified Communications Manager to provision the emulator to your IP phones.

Procedure

Step 1 Press Settings on your Cisco IP phone.

Step 2 Press **#.

A confirmation message at the bottom of the touchscreen says, “Settings Unlocked!”

	User Guide for Cisco Digital Media Manager 5.2.x
15-8	OL-15762-03