Cisco Systems 5.2.x Connect to a Digital Display or Projector, When you will use Hdmi, Does your

Chapter 14 Touchscreens, Projectors, and Displays

Procedures

Procedures

•Connect to a Digital Display or Projector, page 14-7

•Connect to a Touchscreen, page 14-8

•Connect to an Analog Display or Projector, page 14-10

•Prepare Equipment, page 14-11

•Configure and Manage Equipment, page 14-15

Connect to a Digital Display or Projector

Timesaver	Is your display a touchscreen? If so, this topic is not for you. Instead, see the “Connect to a Touchscreen” section on
	page 14-8.
	HDMI and DVI differ in their support for audio signals and use connectors that are shaped differently,
	but otherwise are identical. Thus, an adapter can help you to connect to your DMP any presentation
	system that supports DVI but not HDMI. When you do this, however, you must also use a separate signal
	cable to transmit audio signals, or there will not be any audio.

Before You Begin

•Obtain an HDMI-to-DVI adapter if your presentation system uses DVI.

Procedure

Step 1 Do only one of the following.

•Does your presentation system use an HDMI interface?

When you will use HDMI

a.Connect the HDMI cable to the HDMI interface on the back panel of your DMP.

b.Connect the other end of the cable to your presentation system.

• Does your	When you will use DVI
presentation	a. Connect the HDMI cable to the HDMI interface on the back panel of
system use a	your DMP.
DVI interface?	b. Fasten an HDMI-to-‘DVI adapter to the free end of the cable.
	c. Connect the free end of the DVI adapter to the corresponding
	interface on your presentation system.
	d. Plug the 3.5mm audio jack into the Audio interface on the back panel
	of your DMP.
	e. Connect the other end of the audio cable to the corresponding
	interface on your presentation system.

Step 2 If the presentation system is not already turned on, turn it On now.

Step 3 Stop. You have completed this procedure.

	User Guide for Cisco Digital Media Manager 5.2.x
OL-15762-03		14-7