Bosch Appliances D9412GV2 manual D# Door Point, D# Interlock Point, Default, Blank, Selection

D9412GV2/D7412GV2 Program Entry Guide 7.0 RADXAXS

EN 145

Table 44: Effects of Programming on Custom Function Activation

L## Function	Custom Function Activation
Level?
M	User token activates the custom
(Armed)	function assigned to the Door
	Controller only while the entry area
	for the Door Controller is Master
	Armed or Perimeter Armed.
D	User token activates the custom
(Disarmed)	function assigned to the Door
	Controller only while the entry area
	for the Door Controller is disarmed.
C	User token activates the custom
(Armed and	function assigned to the Door
Disarmed)	Controller regardless of the armed
	state of the entry area.
Blank	User token does not run the custom
	function assigned to the Door
	Controller.

A user’s security level must have an M,

P, or D to operate the custom function.

D# Door Point

Default:	Blank
Selection:	Blank, 1 to 127, 129 to 247
1 to 127,	The point number assigned to this
129 to 247	door. Points 128 and 248 are
	reserved by the control panel for
	internal use.
Blank	No point number is assigned to this
	door.

Enter the point number assigned to this door. This point cannot be used for any other point assignments.

Door points must be programmed as Perimeter points. If a 24-hour point type is required for the Door point, you can use a Perimeter point type with a point response of 9 to C. Also, the debounce count must be set to 4 in Point Assignments.

When assigning Points 1 to 8 (control panel zones), the end-of-line (EOL) resistors must be removed from the control panel.

Also, do not enable any POPIT points (or OctoPOPIT points) sharing the same point number as the Door point. Failure to do so results in extra point trouble conditions upon reboot.

D# Interlock Point

Default:	Blank
Selection:	Blank, 1 to 127, 129 to 247
1 to 127,	The point number assigned to the
129 to 247	Interlock point. Points 128 and 248
	are reserved by the control panel for
	internal use.
	No point number is assigned to the
Blank
	Interlock point.

Enter the interlock point number. This point, when faulted, prevents the door controller from allowing access upon a valid ID read or door request.

Do not assign this point to another D# Door Point. You can, however, assign it to another controller to prevent multiple controllers from activating.

Door points must be programmed as Perimeter points. If a 24-hour point type is required for the Door point, you can use a Perimeter point type with a Point Response of 9 to C. Also, the debounce count must be set to 4 in Point Assignments.

The Interlock point is considered in a normal state if it is bypassed, swinger bypassed, or forced armed. This results in normal access even if the door remains open.

Bosch Security Systems, Inc. 10/08 F01U003636-04