Bosch Appliances D9412GV2 UW# Sunday, UW# Group Enable, UW# Monday, UW# Tuesday, UW# Wednesday

D9412GV2/D7412GV2 Program Entry Guide 5.0 RADXSKED

EN 114

UW# Sunday

Default: No

Selection: Yes or No

UW# Group Enable

Default: 00:00

Selection: HH:MM (hours and minutes)

This prompt, and the next six day of the week prompts, select the days of the week that the User Group Window is active.

Refer to the W# Sunday prompt in Section 5.1.1 Opening and Closing on page 106 for more information about programming this prompt.

UW# Monday

Default: No

Selection: Yes or No

UW# Tuesday

Default: No

Selection: Yes or No

UW# Wednesday

Default: No

Selection: Yes or No

UW# Thursday

Default: No

Selection: Yes or No

UW# Friday

Default: No

Selection: Yes or No

UW# Saturday

Default: No

Selection: Yes or No

This prompt must be programmed if this User Group Window is assigned to a user group.

Enter the time of day when the window starts. Beginning at this time, users assigned to this window’s group can use their pass codes. The window goes into effect at the beginning of the minute. Make entries using a 24-hour clock (for example, 7:00 AM is entered as 07:00, 2:45 PM is entered as 14:45).

If the window must activate on the same day that you program it, reboot the control panel to activate it immediately.

UW# Group Disable

Default: 00:00

Selection: HH:MM (hours and minutes)

This prompt must be programmed if this User Group Window is assigned to a user group.

Enter the time of day when the window ends. This time marks the end of the period in which users assigned to this window’s group can use their pass codes. The window stops at the end of the minute. Make entries using a 24-hour clock (for example, 7:00 AM is entered as 07:00, 2:45 PM is entered as 14:45).

To disable the window, both the hours and minutes spaces must be blank.

Do not program a single window to cross the midnight boundary. The window stop time must be later than the window start time.

Bosch Security Systems, Inc. 10/08 F01U003636-04