Bosch Appliances D9412GV2 manual Phone Supv Time, Dtmf Dialing, Alarm On Fail

D9412GV2/D7412GV2 Program Entry Guide 2.0 GV2MAIN

EN 14

2.2.1Special Point/User Reporting

Independent Zone Control Notice: When using Independent Zone Controls (IZC) to send Opening/Closing Reports by point, do not duplicate reporting independent point numbers with User ID Reports (refer to Section 3.1 Pass Code or Token Worksheet on page 84). For example: If an IZC is connected to Point 8, do not use User ID 8.

D6000: Opening/Closing User ID numbers are identified at the receiver as ZONEs (same identification as independent points). Refer to Table 9.

Table 9: D6000 User IDs and Zones

Phone Supv Time

Default:		Blank
Selection:		Blank or 10 to 240
Blank		No phone line supervision.
10 to 240	Enter the number of seconds (in 10
		sec increments) you wish to wait
		before indicating trouble. After a
		faulted phone line restores, it takes
		the same amount of time to start
		restoral responses.

Phone line trouble responses: Keypads display SERVC PH LINE # to indicate which phone line failed. The keypad initiates a trouble tone if Buzz on

User ID	Zone
Number

1B

2C

3D

4E

5F

66

77

88

User ID	Zone
Number

911

922

933

044

955

960

Fail is Yes and CC Trouble Tone is Yes.

With dual phone lines (using the D928 Module), the restored phone line handles all messages regardless of the phone line’s number.

Phone, Trouble, and Restoral Events report when they occur. They report also when a Diagnostic Report is initiated from a keypad or by a Sked.

To meet UL 864 requirements, set this parameter to a non-zero value.

D6500 or D6600 Receiving BFSK Format: Opening/closing User ID numbers are identified at the receiver as ZN (same identification as independent points). The ZN numbers are based on the tens digit of the User ID number. This applies only for Users 000 through 099. Users 100 through 249 do not report in BFSK format.

DTMF Dialing

Default:	Yes
Selection:	Yes or No
Yes	Dials the programmed phone
	number(s) using DTMF.
No	Pulse dialing only.

Use dual-tone multi-frequency (DTMF) to dial the central station receiver phone number(s) for event reports, or to dial the remote programming software (RPS).

Alarm On Fail

Default: No

Selection: Yes or No

Yes	Generate alarm responses when a
	phone line fails.
No	Phone failures report as trouble
	responses for Area 1 or the account
	number associated with Area 1.

To meet UL 864 requirements, set this parameter to No.

Phone Supv Time must be programmed to use this feature.

Phone Failure Alarm Responses: The Alarm Bell relay for Area 1 activates. All Phone Event messages report as Area 1 and the account number for Area 1.

Bosch Security Systems, Inc. 10/08 F01U003636-04