Bosch Appliances D9412GV2 Call Back Enabled, Passcode in .7 RPS, Command, Contact RPS?, Prev, Ent

D9412GV2/D7412GV2 Program Entry Guide 6.0 GV2AUX

EN 129

Call Back Enabled

Default:	No
Selection:	Yes or No
Yes	When the control panel hears the
	correct RPS password (refer to RPS
	Passcode in Section 2.7 RPS
	Parameters on page 32), it ends the
	SDI RPS session and then
	reconnects to RPS using the RPS IP
	Address if Enable Ext Modem is set
	to No.
	If Enable Ext Modem is set to Yes,
	the control panel re-establishes
	communication with RPS using the
	RPS Dial String. This ensures that
	the control panel communicates only
	with valid RPS units.
No	The SDI RPS session starts
	immediately; no call-back is
	required. The control panel can
	engage in SDI RPS sessions
	regardless of the originating location.

Using this function allows the control panel, after verifying the RPS pass code, to provide an additional level of security. Before allowing any upload or download, it ends the SDI RPS session and then reconnects with RPS using one of the following:

•The RPS IP Address (Enable Ext Modem must be set to No)

•The RPS Dial String (Enable Ext Modem must be set to Yes)

Do not enable RPS Call Back when using an external modem.

Figure 6: COMMAND 43 Flow Chart
	1
	2	3	4
	11	9	11
	9		10
		6	7
			11
	10
	5	8
1 -	COMMAND 43		7 - Begins RPS session over the network
2 -	Contact RPS?		8 - Seizes phone line and begins RPS session
3 -	RPS via Phone?		9 - [PREV]
4 - Seizes phone line and calls RPS			10 - [NEXT]
5 -	Answer now?		11 - [ENT]
6 - RPS by network?

Bosch Security Systems, Inc. 10/08 F01U003636-04