Bosch Appliances D9412GV2 manual 2.5Power Supervision, AC Fail Time

D9412GV2/D7412GV2 Program Entry Guide 2.0 GV2MAIN

EN 28

Table 21: Event Descriptions, Priorities, and Numbers, continued

	Event
	Priorit	Event
Event Description	y	Number
Parameters Changed	008	054
RPS Access OK	008	064
RPS Access Fail	008	065
Remote Reset	008	079
Program Access OK	n/a	n/a
Program Access Fail	n/a	n/a
Service Start	008	029
Service End	008	030
Fire Walk Start	008	036
Fire Walk End	008	037
Walk Test Start	008	038
Walk Test End	008	039
Extra Point	008	023
Send Point Text	n/a	n/a
RF Low Battery	006	093
RF Battery Restore	006	094
Date Changed	008	059
Time Changed	008	060
Delete User	008	090
User Code Change	008	056
Area Watch	008	042
Card Assigned	008	110
Change Level	007	061
Access Granted	008	003
No Entry	008	115
Door Left Open	008	116
Cycle Door	008	112
Door Unlocked	008	113
Door Secure	008	114
Door Request	008	117
Door Locked	008	145
User Alarm COMMAND 7	002	005
User Alarm COMMAND 9	002	006

2.5Power Supervision

AC Fail Time

Default: 1

Selection: 1 to 90 (Blank and 0 are invalid)

Program the amount of time that AC power must be off before the control panel responds to the AC failure. The response to restoral of AC power is delayed for the same amount of time. The control panel always monitors AC. The response to this prompt is the actuation of the relay programmed in the Panel-Wide Relays prompt AC Failure (refer to Section 2.13.2 Panel-Wide Relays on page 81) and the AC Fail report enabled by the AC Fail/Res Rpt prompt. Local annunciation of an AC failuter is controlled by the AC Fail Display prompt.

UL 864 requirements, Section 50.2.1.b states: “A trouble signal shall be transmitted for remote station, central station, and proprietary-type protected premises units after a delay of between 60 and 180 min.

Exception: Products are not prohibited from providing capability of selecting that the primary power failure trouble signal transmission be delayed other time periods, including no delay,provided the 60 – 180 min delay is also included.”

To meet UL 864 requirements, program AC Fail Time with 61, 63, 65, ... (odd numbered values), and 89. Always check with the Authority Having Jurisdiction for local requirements.

When you program AC Fail Time, if the second digit is:

•1, 3, 5, 7, or 9 (such as 3, 5, 11, 13, 15, 21, and so on): The AC Fail Time interval is in minutes.

•2, 4, 6, 8, or 0 (such as 2, 4, 6, 10, 12, 20, 22, and so on): The AC Fail Time interval is in seconds.

For the following items to be true, AC Fail/Res Rpt must be programmed as Yes and AC Tag Along must be programmed as No.

Bosch Security Systems, Inc. 10/08 F01U003636-04