Bosch Appliances D9412GV2 manual Diag Reports

D9412GV2/D7412GV2 Program Entry Guide 2.0 GV2MAIN

EN 20

Table 13: Test Reports

Report	Selection	Report
	s	Description
R# S: Alarm1	Yes, No	Status Alarm
R# S: Trouble1	Yes, No	Status Trouble
R# S:	Yes, No	Status Supervised
Supervised2
R# Status	Yes, No	Status
Report
R# S: Open1	Yes, No	Status Open
R# S: Close1	Yes, No	Status Close
R# Test Report	Yes, No	Test
R# S: Perim	Yes, No	Status Perimeter
Inst1		Instant Arm
R# S: Perim	Yes, No	Status Perimeter
Delay1		Delay Arm
R# S: Fire	Yes, No	Status Fire
Supv2		Supervision
R# S: Fire	Yes, No	Status Fire Alarm
Alarm3		Report
R# S: Fire Trbl2	Yes, No	Status Fire Trouble
R# S: Msng	Yes, No	Status Fire Missing
Fire2
R# S:	Yes, No	Status Burg
MsngBurgTr2		Missing Trouble
R# S:	Yes, No	Status Burg
MsngBurgAl2		Missing Alarm
R# S:	Yes, No	Status Fire
FireSpMsng2		Supervision
		Missing
R# S:	Yes, No	Status Non-fire
SuperMsng2		Supervision
		Missing
R# S:	Yes, No	Status Door Left
DrLeftOpen2		Open

1 Information about this condition is sent with a Status Report.

2 Information about this condition is sent as S: Trouble Event with a Status Report.

3Information about this condition is sent as S: Alarm Event with a Status Report.

Diag Reports

Selecting Yes enables sending a report when the event occurs. If the off-normal state of the events indicated by footnote 1 in Table 14 on page 20 still exists, the events report when a Test Report is enabled and Expanded Test Rpt is programmed Yes. Refer to the Test Reports sub-prompt in Section 2.3.8 Dialing Attempts on page 16.

Table 14: Diagnostic Reports

Report	Selection	Report
	s	Description
R# SDI Dev Fail1	Yes, No	SDI device
		failure
R# SDI Dev Restl	Yes, No	Restoral of SDI
		device failure
R# Watchdog Rset	Yes, No	Watchdog
		Reset Event
R# ParaChksmFail	Yes, No	Parameter
		checksum
		failure
R# Reboot	Yes, No	Reboot Event
R# Ph Line Fail1	Yes, No	Failure of
		phone line
R# Ph Line Rstl	Yes, No	Restoral of
		phone line
		after failure
R# AC Fail1, 2￿	Yes, No	Failure of AC
		power to
		control panel
R# AC Restorl 2	Yes, No	Restoral of AC
		power to
		control panel
		after failure
R# Batt Missing1, 2	Yes, No	Battery Missing
		Detection
		Event
R# Battery Low1, 2￿	Yes, No	Low battery
		power
R# Battery Rstl 2	Yes, No	Restoral of
		battery power
		to control panel
		after Missing or
		Low Event
R# Rt Comm Fail1,	Yes, No	Failure to send
3		report to
		specific route
R# Rt Comm Rstl	Yes, No	Restoral of
		communication
		to specific
		route after a
		failure

Bosch Security Systems, Inc. 10/08 F01U003636-04