Bosch Appliances D9412GV2 manual W# Close Early Begin, Default, Selection, HH:MM hours and minutes

D9412GV2/D7412GV2 Program Entry Guide 5.0 RADXSKED

EN 109

Table 35: Programming for Two Same Day Opening Windows (refer to Figure 5)

W#

1

2

Day of Week

S M T W T F

S

S M T W T F

S

Open Close

Early			Early
Begin	Start	Stop	Begin	Start	Stop
06: 00	07 : 00	08: 00
13 : 00	14 : 00	15 : 00

eXcept On

Holiday

Yes / No

Yes / No

Holiday

Index

1 2 3 4

1 2 3 4

Area(s)

1 2 3 4 5 6 7 8

1 2 3 4 5 6 7 8

Do not program a single window to cross the midnight boundary. The window stop time must be later than the window start time. To program a window that effectively crosses the midnight boundary, you must program two windows.

For example, to program windows for an area that opens between 11:30 PM and 12:30 AM, five days a week, use two windows as shown in Table 36.

Table 36: Programming to Link Two Days over Midnight*

W#

1

2

Day of Week

S M T W T F S

S M T W T F S

Open Close

Early			Early
Begin	Start	Stop	Begin	Start	Stop
22 : 00	23 : 30	23 : 59
00 : 00	00 : 00	00 : 30

eXcept On

Holiday

Yes No

Yes No

Holiday

Index

1 2 3 4

1 2 3 4

Area(s)

1 2 3 4 5 6 7 8

1 2 3 4 5 6 7 8

* The setting for midnight is 00:00.

W# Close Early Begin

Default:	00: 00
Selection:	HH:MM (hours and minutes)
	00:00 to 23:59

Close Early Begin: This program item is one of three required to create a Closing Window. To finish programming a Closing Window, Close Window Start and Close Window Stop must be programmed.

The time programmed in the Close Early Begin field is the earliest time the user can close an area before the Closing Window Start time. If Opening and Closing Reports are enabled, arming the area between midnight and the Close Early Begin time generates a Closing Report. Additionally:

•If A# Disable O/C in Window is set to Yes and the area is armed between the Close Early Begin time and the Close Window Start time, the Closing Event is sent with an Early to Close modifier. If the Close Early Begin time is the same as the Close Window Start time, no Closing Event is sent.

•If A# Disable O/C in Window is set to No and the area is armed at any time, a Closing Event is

sent without the Early to Close or late to Close modifiers.

Arming the area between the Close Window Start and Close Window Stop times creates a local event in the control panel event log, but does not send the Closing Report to the central station.

Arming the area after the Close Window Stop time and before the next window’s Close Early Begin time (or midnight, whichever is earlier) generates a Closing Event with a Late to Close modifier.

When configuring multiple windows to operate on the same day, ensure that they are added to the system in chronological order. For example, if three windows are programmed to execute on Tuesday, Window 1 (W1) must occur before Window 2 (W2), and Window 2 must occur before Window 3 (W3).

Avoid programming the Open Early Begin time before a time that is between another window’s Open Window Start and Open Window Stop times.

Disabled windows have a blank beginning time. If the entry for this prompt is blank, but times are programmed for Close Window Start and Close Window Stop, the window is disabled.

Bosch Security Systems, Inc. 10/08 F01U003636-04