Bosch Appliances D9412GV2 manual Phone, Default Blank Selection Up to 24 characters do not enter

D9412GV2/D7412GV2 Program Entry Guide 2.0 GV2MAIN

EN 11

2.0 GV2MAIN

Use GV2MAIN programming module to define the operating characteristics that affect panel-wide functions. This module has nine programming categories:

•Phone

•Phone Parameters

•Routing

•Enhanced Communications

•Area Parameters

•Keypad

•User Interface

•Function List

•Relay Parameters.

2.1Phone

The control panel can dial as many as four different telephone numbers when sending event reports. All telephone numbers use the same receiver format.

Refer to Section 2.3 Routing on page 15 for information about event report routing and communication protocols.

When using PSTN telephone lines, program two telephone numbers to meet UL 864 requirements.

Phone 1

Default:	Blank
Selection:	Up to 24 characters (do not enter
	[SPACE])
0 to 9	Numbers 0 through 9

C3-sec pause

D7-sec dial-tone detection

# or *	Used for the same purpose as
	pressing this key on a telephone
	keypad when manually dialing. For
	example, an asterisk (*) may be
	needed to access your long distance
	service. Do not use these characters
	when pulse dialing.
Blank	Control panel dials no phone number.
	Programming this item Blank does
	not disable phone routing. To disable
	reporting to this phone, refer to
	Section 2.3 Routing on page 15.

This is the telephone number the control panel dials to contact the central station receiver when sending event reports. This number is Phone 1 referred to in the prompts in Section 2.3 Routing on page 15.

The control panel is programmed with a 7-sec dial tone detect period. When a dial tone is detected or the waiting period ends, the control panel begins to dial. To extend the dial tone detect period, place a D before the phone number. To insert a pause during or after dialing, use C in the number sequence. For example, if the control panel hangs up before it hears the Modem IIIa2 ACK tone from the D6500 or D6600, program extra Cs after the phone number. The control panel waits on line for three extra seconds for each C programmed.

Enter up to 24 of the characters shown in the Phone 1 table to define dialing characteristics.

Using both phone-data entry lines: The first line of the phone number data entry line must be filled (twelve characters) before you press [ENTER] to move to the second line. If you enter characters on the second line, and the first line has less than twelve characters, the second line clears when you press [ENTER].

For SIA CP-01 Compliance

Call Waiting Disable

If the telephone system at the installation site uses the Call Waiting feature, ensure that the backup telephone reporting number is programmed to disable Call Waiting.

If you program the primary phone number with a sequence to temporarily disable Call Waiting (typically *70 pause, but verify with the phone service provider) followed by the phone number, you should program the backup phone number without the Call Waiting cancel sequence. If the subscriber cancels Call Waiting without notifying their alarm installing company, the control panel can still send reports using the backup number.

Dialing a Call Waiting sequence on a non-Call Waiting line prevents the system from dialing the central station receiver successfully.

Example: If the central station telephone number is 555-1234, and the backup Route Group destination is Phone 2, program Phone 2 with the following sequence: 70C5551234.

Bosch Security Systems, Inc. 10/08 F01U003636-04