Bosch Appliances D9412GV2 CC# Area Assign, CC# Scope, CC# A1through A8 in Scope, CC# Entr Key Rly

D9412GV2/D7412GV2 Program Entry Guide 2.0 GV2MAIN

EN 52

CC# Area Assign

Default: 1

Selection: 1 to 8

Blank is not a valid entry.

Enter the area number where you are installing this keypad or keypads with this address and the same DIP switch settings.

CC# Scope

Default:	Refer to the program record sheet
Selection:	Panel Wide, Custom, No Keypad,
	Area, and Account
Panel	A panel-wide keypad can view
Wide	information and perform Arming and
	Disarming functions for all areas in
	the control panel. A panel-wide
	keypad can cross account
	boundaries. This is normally used
	with a master area.
Account	An Account keypad can view
	information, and perform Arming and
	Disarming functions for all areas with
	the same A# Acct Number, in Area
	Parameters. This is normally used for
	an associate area.
Area	An area keypad is restricted to
	viewing information and Arming or
	Disarming functions for the area to
	which it is assigned.
Custom	A custom keypad has no keypad
	restrictions.
No	No keypad installed at this address.
Keypad	CALL FOR SERVICE display shows,
	indicating the control panel is not
	polling this address.

This program item is used to define the areas affected when an arming command is executed on this keypad, the areas this keypad can view, and the areas to which this keypad can move.

Press the [SPACE] bar to scroll through the selections. Press [ENTER] when the correct selection appears in the display.

In applications where keypads include more than one area, active alarms in remote areas must be acknowledged before arming or disarming the local area.

The following prompt is visible only when you program CC## Scope to Custom. If you change the keypad scope selection to Custom from Panel Wide, Account, or Area, the settings from the previous CC# Scope selection become the default settings for the custom parameters in CC# A1 [through A8] in Scope. Before exiting from a custom program, check each area and ensure that it is enabled and disabled correctly.

CC# A1[through A8] in Scope

Default:	Refer to the preceding important
	note
Selection:	Yes or No
Yes	Include this area in the scope of this
	keypad.
No	Do not include this area in the scope
	of this keypad.

Determines whether any of the eight areas (Area 1 to Area 8) and Doors (Door 1 to Door 8) are included in the scope of this keypad for viewing status, arming or disarming, and controlling doors from the keypad.

CC# Entr Key Rly

Default:	Blank
Selection:	1 to 128, A, B, C, and Blank
Blank	The [ENTER] key is not used to
	activate a relay.
1 to 128,	Assign the relay number that
A, B, C	activates when [ENTER] is pressed at
	this keypad after the user enters a
	valid pass code.

Enter Key Relay: Program the relay number that activates momentarily for 10 sec when a user enters a valid pass code and presses the [ENTER] key on the keypad. Two events are generated when this function is used: RELAY ### SET with User ID, and RELAY

###RESET without User ID. The system logs this action as two events.

•Entering a valid code and pressing [ENTER] silences a ringing bell.

•Using CC# Entr Key Rly for a low-level access control strike on a door does not shunt a point.

Bosch Security Systems, Inc. 10/08 F01U003636-04