Bosch Appliances D9412GV2 manual RPS Call Back, RPS Line Monitor, Answer Armed, Answer Disarmed

D9412GV2/D7412GV2 Program Entry Guide 2.0 GV2MAIN

EN 34

RPS Call Back

Default:	No
Selection:	Yes or No
Yes	When the control panel hears the
	correct RPS passcode, it hangs up
	the phone, seizes the phone line,
	then dials the programmed RPS
	phone number (refer to the RPS Ph
	prompt on page 35). This ensures
	that the control panel only
	communicates with RPS units
	connected to the programmed phone
	number.
	If the call is answered manually, the
	call back must be initiated manually.
No	The RPS session starts immediately.
	No call back is required. The control
	panel can engage in RPS sessions
	when called from any phone number
	and a proper RPS passcode is
	identified.

This function allows the control panel, after it verifies the RPS passcode, to provide an additional level of security by hanging up and dialing the RPS phone number at the central station before allowing any upload or download.

When using the RPS Call Back feature, be sure to program the character “C” as the last digit in the RPS phone number when using DTMF Dialing.

RPS Line Monitor

Default:	Yes
Selection:	Yes or No
Yes	Allows the control panel to
	communicate with RPS after the
	answering machine answers the
	phone.
No	Use No if the control panel does not
	share the phone line with an
	answering machine.

This program item enables a control panel that shares a phone line with an answering machine to communicate with RPS at the central station, even though the answering machine answers the phone. You must program Answer Armed or Answer Disarmed. The control panel must be in the correct armed state.

Program this item No if it causes false seizures of the phone line or if you do not use RPS. This indicates that a device using the same frequency tone is also using the phone line to which the control panel is connected.

If RPS Call Back is programmed Yes, the control panel hangs up the phone after the RPS tone and a proper RPS passcode is identified. It then calls the RPS phone number.

Answer Armed

Default:	Refer to the program record sheet
Selection:	1 to 15, or Blank
Blank	No answer.
1 to 15	The control panel answers the phone
	after the specified number of rings
	when all areas are master armed.

Set the telephone ring counter to answer when all areas are master armed. If any area in the control panel is perimeter armed or disarmed, the Answer Disarmed ring counter is used.

The remote programming software (RPS) considers perimeter armed as a disarmed state.

Answer Disarmed

Default:	Refer to the program record sheet
Selection:	1 to 15, or Blank
Blank	No answer.
1 to 15	The control panel answers the
	phone after the specified number of
	rings when any area in the system is
	in a perimeter armed or disarmed
	state.

Set telephone ring counter to answer when any area is in a perimeter armed or disarmed state.

The RPS considers perimeter armed as a disarmed state.

Bosch Security Systems, Inc. 10/08 F01U003636-04