Bosch Appliances D9412GV2 manual UL 864 Programming Requirements continued

D9412GV2/D7412GV2 Program Entry Guide 1.0 Introduction

EN 10

Table 5: UL 864 Programming Requirements (continued)

Product Feature/Option Permitted in UL 864? (Y/N)

Possible Settings

Settings Permitted in UL 864

Refer to Page:

For IP Communications to a D6600 Receiver
Enhanced Comm	Yes	Yes / No	Set to Yes	135
Path1 IP Add1 (2, 3 or 4)	Yes	000 to 255	Program a valid IP	135 − 136
			address
Path 1 Poll Rate	Yes	0, 5 to 65535 sec	Program as necessary	136
Path 1 Ack Wait	Yes	0, 5 to 65535 sec	Program as necessary	137
Path 1 Retry Count	Yes	0 to 255	Program as necessary	138
9133 Supervision	Yes	Yes / No	Set to Yes	139

The following programmable parameters are recommended by Bosch when installing a commercial fire alarm system. Always check with your local Authority Having Jurisdiction.

Table 6: UL 864 Programming Recommendations

Prompt	Possible Settings
Phone Line Fail Report	Yes / No
Phone Line Restoral Report	Yes / No
Fire Walk Start Report	Yes / No
Fire Walk End Report	Yes / No
Cancel Report	Yes / No
CC# Scope	Panel Wide, Account Wide, Area
	Wide, Custom, No Keypad
CC# EnhancCmdCtr	Yes / No
CC# Menu Key Lock	Yes / No
Reset Sensors	Disable/Enable/Passcode Protect
Fire Test	Disable / Enable / Passcode Protect
L## Reset Sensors	Disable / Enable
L## Fire Test	Disable / Enable
U### User Group	Blank, 1 to 8
P## Ring Til Rst	Yes / No
P## Cross Point	Yes / No
D# Fire Unlock	Yes / No

Recommendation

Yes

Yes

Yes

Yes

Yes

Do not program No Keypad

Set to Yes, if applicable

If using D1256RB, set to No Enable

Enable

If Reset Sensor is set to Passcode Protect, set this to Enable

If Fire Test is set to Passcode Protect, set this to Enable

Program as blank

May be required for Waterflow, otherwise No

Set to No for Fire devices.

No

Bosch Security Systems, Inc. 10/08 F01U003636-04