Bosch Appliances D9412GV2 manual Route Group Attempts, RG# 1 Attempt, Fire Summary Sustain

D9412GV2/D7412GV2 Program Entry Guide 6.0 GV2AUX

EN 139

RTS Control

Default:	On
Selection:	On, AutoX, Off, AutoR
On	Sets RTS to on (hardware control).
Auto X	Automatically enables Xon/Xoff
	(software control).
Off	Sets RTS off (hardware control).
Auto R	Sets this to Auto RTS.

Determines how the Request To Send (RTS) control parameters are defined for the network interface module (NIM). Pressing the [SPACE] bar on the D5200 toggles through the available options.

Set this item to On when using the

External Modem feature.

DTR Control

Default:	On
Selection:	On, AutoD, Off
On	Sets DTR to on (hardware control).
AutoD	Sets this to Auto DTR.
Off	Sets DTR off (hardware control).

Determines how the Data Terminal Ready (DTR) control parameters are defined for the network interface module (NIM). Pressing the [SPACE] bar on the D5200 toggles through the available options.

Trouble SDI 88 Reports are always reported using the account number for Area 1.

6.7Route Group Attempts

This section determines how many times a route group tries the primary destination before trying the backup destination if the primary destination fails. This entry applies to both Phone numbers and IP addresses.

RG# 1 Attempt

Default:	No
Selection:	Yes or No
Yes	This route group tries the primary
	destination once and, if
	unsuccessful, tries the backup
	destination. The control panel still
	makes a total of ten attempts (five to
	the primary, five to the backup)
	before generating a route group
	Comm Fail Event.
No	This route group tries the primary
	destination twice and, if
	unsuccessful, tries the backup
	destination. The control panel makes
	a total of ten attempts (six to the
	primary, four to the backup) before
	generating a route group Comm Fail
	Event.

Set this item to On when using the

External Modem feature.

9133 Supervision

Default:	No
Selection:	Yes or No
Yes	Supervise the network interface
	module (NIM).
No	Do not supervise the network
	interface module (NIM).

This item determines whether the NIM is supervised. If the NIM is supervised, disconnecting it from the control panel creates a Trouble SDI 88 Event and the keypad annunciates a trouble tone and displays SERVC SDI 88.

6.8Miscellaneous

Fire Summary Sustain

Default:	No
Selection:	Yes or No
Yes	Forces the Summary Fire relay
	output to remain on after the Alarm
	Silence command.
No	Allows Summary Fire relay output
	to be silent when the Fire Alarm Bell
	output is silenced and all Fire Points
	return to normal.

Use this parameter to set the Summary Fire relay output to continue or to stop after the Fire Alarm Bell is silenced or times out. Refer to the Summary Fire prompt in Section 2.13.2 Panel-Wide Relays on page 82.

Bosch Security Systems, Inc. 10/08 F01U003636-04