Bosch Appliances D9412GV2 S## Cmd Center, Cmd Center and Custom Func, S## Custom Func, Default

D9412GV2/D7412GV2 Program Entry Guide 5.0 RADXSKED

EN 119

Default:		Blank
Selection:		1 to 11, 13 to 24, 28, 29
11	Execute Custom Func: This		S## Cmd Center	Blank	No keypad is
	function emulates any of the custom			(0)	specified for
	functions assigned to the keypad		Default: Blank (0)		Custom Function
	that can be executed by a user from		Selections: Blank (0), 1 to 8		activation.
	the keypad. When a sked executes
			Identify the specific keypad	1 to 8	Command center
	a custom function, it is subject to
	the scope of the selected keypad.		(CC #) where the Custom		(keypad) address
	Cmd Center and Custom Func		Function is entered. Only one		specified for
	prompts appear after entering		keypad can be assigned for		Custom Function
	Function Code 11. Both entries are		this sked function.		activation.
	required.
			S## Custom Func	Blank	No Custom
				(0)	Function is
			Default: Blank (0)		activated.
			Selections: Blank (0),	128 to	Custom Function
			128 to 143 for D9412GV2,	143	to activate.
			128 to 131 for D7412GV2
			Enter the custom function this
			sked executes.

Avoid having multiple functions occur at the same time at the same address. Functions can clash and the effect on the control panel is unpredictable.

Ensure that the Custom Function being executed or any of the commands nested inside the Custom Function are not pass-code protected.

Do not program multiple skeds to execute at the same keypad during the same time.

Do not program skeds to execute at times when a user is likely to be executing functions at the keypad. If it is necessary to do so, there are two ways to work around the situation:

1.Program CC at the beginning of the Custom Function Key Strokes entry. This aborts the user’s function and allows the sked to execute.

2.Program the sked to execute at an address (Cmd Center) with no keypad physically attached to it. The CC # must be assigned to an area and have the appropriate scope programmed.

Default: Blank

Selection: 1 to 11, 13 to 24, 28, 29

13Adjust Time Forward One Hour: This sked function is used to make adjustments to the control panel’s clock. A typical application is to program this to go into effect at 2:00 AM on the date that Daylight Saving Time begins (during the springtime). No Time Change Report is sent or logged, but the new time appears in the next report logged.

No other parameters require input for this option.

14Adjust Time Backward One Hour: This sked function is used to make adjustments to the control panel’s clock. A typical application is to program this to go into effect at 2:00 AM on the date that Daylight Saving Time ends (during the fall). This function can operate only once in a day, even if multiple Skeds with this function are programmed. No Time Change Report is sent or logged, but the new time appears in the next report logged.

There are no other parameters that require input for this option.

Bosch Security Systems, Inc. 10/08 F01U003636-04