Bosch Appliances D9412GV2 manual Relay Reports, AutoFunc Reports, RPS Reports

D9412GV2/D7412GV2 Program Entry Guide 2.0 GV2MAIN

EN 21

Table 14: Diagnostic Reports (Continued)

Report	Selections	Report
		Description
R# Checksum Fail	Yes, No	Checksum Fail
		Event
R# Network Fail4	Yes, No	Failure of
		network
R# Network Rest4	Yes, No	Restoral of
		network
R# Network Cond4	Yes, No	Condition of
		network

1This event is included in the Expanded Test Report when an off-normal condition exists..

2To meet UL 864 requirements for Central Station and

Remote Station applications, enable AC Fail, Battery Missing, Low Battery, Battery Restoral, and AC Restoral reports.

3This event covers Comm Fail Route Group and Comm Fail Phone. If enabled, both events are sent; if disabled, neither event is sent

4 This event is reserved for future use.

Enable Rt Comm Fail and Rt Comm

Restore in only one route group.

Relay Reports

Selecting Yes enables sending a report when the event occurs.

Table 15: Relay Reports

Report	Selections	Report
		Description
R# Sensor	Yes, No	Sensor Reset
Reset		Event
R# Relay Set	Yes, No	Relay Set Event
R# Relay	Yes, No	Relay Reset Event
Reset

When activating an on-board relay using remote automation software, the D9412GV2 and D7412GV2 Control Panels log and print the resulting event as:

Relay 250 (Relay A)

Relay 251 (Relay B)

Relay 252 (Relay C)

AutoFunc Reports

The following prompts support customized routing of Auto Function Reports. Selecting Yes enables a report to be sent when the event occurs.

Table 16: Auto-Function Reports

Report	Selections	Report Description
R# Sked	Yes, No	Sked Executed
Executed		Event
R# Sked	Yes, No	Sked Changed
Changed		Event
R# Execute	Yes, No	Fail to Execute
Fail		Event

RPS Reports

Selecting Yes enables sending a report when the RPS Passcode Event occurs.

RPS Access Fail can indicate a wrong RPS passcode when communicating with the control panel or a valid RPS session terminated by a means other than a Good-bye or Reset-bye command. Remote Reset indicates a Reset-bye command issued from RPS; Bad Call to RPS indicates the control panel called RPS but was unable to connect.

Bosch Security Systems, Inc. 10/08 F01U003636-04