42ENSPECIALFEATURES

Remote

Control

Functions

PLAY

VCR

NUMBER "1"

OK

Remote A/B Code Switching

The remote control is capable of controlling two JVC video recorders independently; one set to respond to the remote control's A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your video recorder is initially set to respond to A code signals. You can easily modify your video recorder to respond to B code signals.

SET REMOTE CONTROL

CODE FOR REMOTE

CONTROL

121Press and hold VCR.

3Press the NUMBER key “2”. Press OK, and release VCR.

The remote control now can transmit B code control signals.

CHECK REMOTE CONTROL CODE FOR RECORDER

2Press and hold PLAY on the recorder for more than

5 seconds while the recorder is turned off. The code currently set appears on the display panel.

CHANGE CODE FOR

RECORDER

3Press any key on the remote control. The recorder now responds to B code control signals.

To control two recorders with the same remote control

You can control two JVC recorders by switching the remote control code for the remote control between A and B ( step 1), keeping two recorders to different control codes.

To change only the remote control code for the remote control, DO NOT perform steps 2 and 3.

NOTE:

To set the recorder back to respond to A code signals, repeat the same procedure as shown above except pressing NUMBER key "1" instead of "2" in step 2of 1.

Page 42
Image 42
JVC HR-S5900AM Remote Control Functions, SET Remote Control Code for Remote, Change Code for Recorder, EN Special Features