advanced features

Video Channel Set

59

before you start

The power cord must be plugged in and connected to the VCR

The VCR must be turned off and no cassette inserted

The Remote Control must have batteries inserted

The TV set must be turned on

The VCR can send picture signals to the TV set in one of two ways; RF (ordinary cable included with this VCR) and AV (via a 21-pin SCART cable available from TV and Hi-Fi dealers). Depending upon which method you use, the VCR must have the correct method set up in order to work. The Auto Setup procedure normally takes care of this but if for any reason this fails to happen, the instructions below describe how to set the Video Channel manually.

Access Video Channel Mode

Press and hold the Sbutton on the VCR until the display panel shows the following informa- tion:

Set Video Channel

for av connection Press Buntil the display panel shows:

The Video Channel is now set to OFF. Go to Step 3.

for rf connection Press Aor Bto set the VCR to a vacant channel number between 22 and 69 which is not occupied by any station in

your area (refer to station list on page 65). In the example, we have presumed that channel 36 is vacant and have set the VCR to 36:

Now tune the TV set to channel 36 (refer to TV manual if necessary); you should see two vertical white bars appear on the TV screen. If the bars do not appear or are not clear, choose another vacant channel and try again. If you cannot obtain the vertical white bars on any channel between 22 and 69, consult your local JVC dealer.

Exit Video Channel Set Mode

Press O.

To view pictures from your VCR you must now set your TV to either the Video Channel or to AV mode, depending upon your choice above.

Page 59
Image 59
JVC HR-S6857EK, HR-S6855EK, HR-S6856EK manual Access Video Channel Mode, Set Video Channel, Exit Video Channel Set Mode