JVC HR-S9900U manual 58 EN, For Example

58 EN		OTHER USEFUL FUNCTIONS (cont.)
		* The default setting is bold in the table below.
 AUTO SP = EP TIMER	When this function is set to “ON”, the VCR automatically switches to EP
ON	mode to allow complete recording if there is not enough tape to record
	the entire program while timer-recording in SP mode.
OFF
	For Example . . .
	Recording a program of 140 minutes in length onto a 120-minute tape
		Approximately 110 minutes	Approximately 30 minutes
		SP mode	EP mode
	Make sure you set this function to “ON” before the timer-recording starts.
	NOTES:
	● If you have programed the VCR to timer-record 2 or more programs, the second
	program and those thereafter may not fit on the tape with this function set to
	“ON”. In this case, do not use this function, but change the tape speed
	manually during timer programing.
	● In order to ensure that the recording fits on the tape, this function may leave a
	slight non-recorded portion at the end of the tape.
	● There may be some noise and sound disturbance where the tape speed switches
	from SP to EP mode on the tape.
	● This function is not available during ITR (Instant Timer Recording), and will not
	work properly on the following tapes: T(ST)-30, T(ST)-60, T(ST)-90, and T(ST)-
	120.
 DIGITAL R3	When this function is set to “ON”, edge correction to the luminance
ON	signal is performed to enhance details. Normally set this function to
	“ON”.
OFF
	NOTES:
	● Depending on the type of tape being used, picture quality may be better with
	“DIGITAL R3” set to “OFF”.
	● If you use this VCR as the playback VCR for editing, be sure to set “DIGITAL
	R3” to “OFF” before starting.
 VIDEO STABILIZER	When this function is set to “ON”, you can automatically correct vertical
ON	vibrations in the picture when playing back unstable recordings made on
OFF	another VCR.
	NOTES:
	● When you finish viewing a tape, be sure to set this function to “OFF”.
	● Regardless of the setting, this function has no effect during recording and during
	special effects playback.
	● The on-screen display may jitter vertically when this function is set to “ON”.
	● To watch recordings with close-caption, set this function to “OFF”.
	● Video Stabilizer and Digital TBC/NR cannot be used at the same time. If you
	activate Digital TBC/NR when “VIDEO STABILIZER” is set to “ON”, Video
	Stabilizer will be automatically turned “OFF”.
 2ND AUDIO RECORD	When this function is set to “ON”;
ON	● If a SAP program is received, the SAP audio is recorded on both the
	normal and Hi-Fi tracks. The main audio is not recorded.
OFF
	● If a non-SAP program is received, the main audio is recorded on both
	the Hi-Fi and normal tracks.
	When this function is set to “OFF”, the SAP audio cannot be recorded.
			Refer to page 56 for setting procedures.