JVC HR-VP68U manual Turn on DBS receiver, Access DBS Receiver Set screen

DBS RECEIVER SET

OFF

PRESS (5,°), THEN (OK)

PRESS (MENU) TO END

INITIAL SET

CLOCK SET

LANGUAGE ENGLISH GUIDE CHANNEL SET CABLE BOX SET

=DBS RECEIVER SET

SELECT WITH (5,°) AND (OK)

PRESS (MENU) TO END

Access Main Menu screen on VCR Press MENU.

EN 19

Turn on the VCR and the TV, and select the VCR channel 3 or 4 (or AV mode) on the TV.

2

34

SP EP

VCR

3–5

1 2 3

2

4 5 6

7 8 9

0 4

1

2	34
	3–5

Setting DBS receiver output channel & brand

After installation, set the DBS receiver’s output channel and its brand correctly; otherwise, the Controller cannot work correctly.

1 Turn on DBS receiver

Select a channel other than channel 55, 100 or 205 on your DBS receiver.

2

3 Access Initial Set screen

On the front panel:

Press CH5° to move the highlight bar (arrow) to “INITIAL SET”, then press OK.

On the Remote:

Press SHUTTLE PLUS %Þ to move the highlight bar (arrow) to “INITIAL SET”, then press OK or

SHUTTLE PLUS #.

4 Access DBS Receiver Set screen

On the front panel: Press CH5° to move the highlight bar (arrow) to “DBS RECEIVER SET”, then press OK.

On the Remote:

Press SHUTTLE PLUS

%Þ to move the highlight bar (arrow) to “DBS RECEIVER SET”, then press OK or SHUTTLE PLUS #.

5Select DBS receiver output channel

Your selection depends on how your DBS receiver is connected to your VCR.

If your DBS receiver is connected to your VCR’s ANT. IN terminal on the rear

Press CH 5° on the front panel or SHUTTLE PLUS %Þ on the Remote until the channel number representing the DBS receiver’s output (CH3 or CH4) appears on the screen.

If your DBS receiver is connected to your VCR’s AUDIO/VIDEO IN connectors on the front panel Press CH 5° on the front panel or SHUTTLE PLUS %Þ on the Remote until “ON F-1 (FRONT)” appears on the screen.

If your DBS receiver is connected to your VCR’s AUDIO/VIDEO IN connectors on the rear panel Press CH 5° on the front panel or SHUTTLE PLUS %Þ on the Remote until “ON L-1 (REAR)” appears on the screen.

If you do not use a DBS receiver

Press CH 5° on the front panel or SHUTTLE PLUS %Þ on the Remote until “OFF” appears on the screen.

CONTINUED ON NEXT PAGE \