JVC HR-VP68U manual Express Timer Programing, 34 EN

34 EN TIMER RECORDING (cont.)

Express Timer Programing

Turn on the VCR and the TV, and select the VCR channel 3 or 4 (or AV mode) on the TV.

You can directly program the VCR’s timer to record up to 8 broadcasts, as far as a year in advance. Remember, the clock must be set before you can program the timer ( pg. 8 or 10).

1 Load a cassette

Make sure the record safety tab is intact. If not, cover the hole with adhesive tape, then load it into the VCR.

The VCR turns on, and the counter is reset, automatically.

2Access VCR PLUS+ screen

Press PROG..

3Access Program screen

1

4

DAILY

7

CANCEL

2 3

2

5	6
8	9	WEEKLY

0 40

Press START +/– once.	PROGRAM 1
(If no program is stored,	START		STOP
“PROGRAM 1”
	– –:– –AM	=	– –:– –AM
appears.)	DATE		CH
	– –/– –/– –		– – –	SP

PRESS (+/–, SP/EP, 8=DAILY,

9=WEEKLY), THEN (0K) PRESS (PROG.) TO END

34
5
29	1

7

6 8

4Set program start time

Press START +/– repeatedly to enter the time you want recording to start.

PROGRAM 1

START		STOP
8:00 AM	=	– –:– –AM
DATE		CH
– –/– –/– –		– – –	SP

9

Press and hold START +/– to increase the time in 30-minute intervals.

PRESS (+/–, SP/EP, 8=DAILY,

9=WEEKLY), THEN (0K) PRESS (PROG.) TO END

5 Set program stop time

Press STOP +/– repeatedly to enter the time you want recording to stop.

Press and hold STOP +/– to increase the time in 30-minute intervals.

6 Set program date

Press DATE +/–. (The current date is displayed on the screen. The date you enter appears in its place.)

7Set channel number

Press CH +/–.

If you are using a DBS receiver, see “ATTENTION FOR DBS RECEIVER USERS” on next page.

Holding down CH +/– rapidly changes the channel numbers.