Additional preparation

Connecting methods

1Connect the TV’s VIDEO jack and the device’s VIDEO OUT (video output) jack with a video cable.

If connecting a device to the TV with an S-VIDEO cable:

Connect the VCR’s S-VIDEO OUT (S- VIDEO output) connector and the TV’s S connector with an S-VIDEO cable, instead of connecting with a video cable.

Note that the connection with a video cable will be ignored in case you connect a VCR to the TV with both video cable and S- VIDEO cable.

If connecting a DVD player to the TV with a component video cable.

Connect three jacks (Y/VIDEO, CB and CR) in the VIDEO-3 terminal and the DVD player’s COMPONENT (component video output) jacks with a component video cables, instead of connection with a video cable. Then set the VIDEO-3 SETTING to COMPONENT, according to“VIDEO-3 SETTING” on page 23.

This Television is compatible with the Progressive video signal (525P signal) only when the component video signal is input.

If you have a DVD player that outputs Progressive video signals (525P) as a component video signal, then by attaching the device to the television with a component video cable you can see the actual images that are recorded on a DVD disc as an original

image source.

If connecting a device to the VIDEO-3/ COMPONENT terminal with a video cable.Connect the TV’s Y/VIDEO jack and the device’s VIDEO OUT (video output) jack with a video cable.

Then set the VIDEO-3 SETTING to VIDEO according to “VIDEO-3 SETTING” on page 23.

In the VIDEO-4 terminal, the VIDEO jack is indicated by “V”.

2Connect the TV’s AUDIO jacks (L/ MONO and R) and the device’s AUDIO OUT (audio L/R output) jacks with an audio cable.

If the device’s sound output is in mono: Connect the device’s AUDIO OUT jack and the TV’s L/MONO jack with an audio cable.

Connecting devices to the OUTPUT terminal

The signals of the images and sound you are currently viewing with this TV are output through the OUTPUT terminal. By connecting a VCR to the OUTPUT terminal, you can record the currently shown image and sound to that VCR. To do this, connect the VCR and OUTPUT terminal following the steps below.

1Connect the VIDEO jack in the OUTPUT terminal and the VCR’s VIDEO IN (video input) jack with a video cable.

2Connect the AUDIO jacks (L and R) in the OUTPUT terminal and the VCR’s AUDIO IN (audio L/R input) jacks with an audio cable.

When you turn off the TV, the signals from the OUTPUT terminal are also turned off.

The component signals input from the VIDEO-3/COMPONENT terminal cannot be output through the OUTPUT terminal.

Connecting Headphones

Connect the headphones with a stereo mini jack (of 3.5 mm in diameter) to the Headphone jack at the TV front panel.

30

Page 30
Image 30
JVC HV-29WH11 manual Connecting methods, Connecting devices to the Output terminal, Connecting Headphones