To cancel NAVIGATION search midway...
Press 8 or 4·9.
PAUSE
Displayed while the captured image is being stored in the memory card.
1h 01m
6 Rotate the MENU Wheel to select the desired image, and press it.
● The “NAVIGATION SEARCH” indication appears blinking and the camcorder starts searching the tape for the relevant point of the selected thumbnail image.
4 5 006
1 2
3
DATE : MAY 2 4 ’ 0 3
TC : 1 3 : 2 3 : 1 5
3 :: 2 9 AM
NAV I GAT I ON
Press NAVI during video playback or stop mode. ● The loaded cassette’s
NAVIGATION thumbnail
image screen appears. ● Press 3 to display the previous page. Press 5
to display the next page.
5
Set the Power Switch to “P” while pressing down the Lock Button located on the switch.
Load a cassette. ( pg. 18)
1
2 Load a memory card. ( pg. 19)
3 Set the Playback Mode switch to “VIDEO”.
4
To make thumbnail images after video recording manually...
1) Perform steps 1 to 3 above.
2) Set “NAVIGATION” to “MANUAL”. ( pg. 35, 36)
3) After the recording, press NAVI STORE. •The “ ” indicator appears briefly and the
captured image is stored in the memory card as a thumbnail image.
NOTES:
● The remaining number of storable thumbnail images also appears on the screen when it reaches
10 or less. If “REC SELECT” is set to “ / ” in DSC Menu, the number shows how many 640 x 480 pixel images can be stored.
● If “5S” is set to “5S” or “Anim.” in MANUAL Menu, the NAVIGATION function will not work properly.
To find scenes on tape using thumbnail images (NAVIGATION Search)

52 EN

NAVIGATION Function

The Navigation Function helps you check tape contents by making thumbnail images on a memory card.

Lock Button

Power Switch

Fast-Forward Button (5)

Rewind Button (3)

Playback Mode Switch

NAVI Button
NAVI STORE Button

MENU Wheel

To make thumbnail images during video recording automatically

1

2

3

Load a cassette. ( pg. 18) Load a memory card. ( pg. 19)

Set the Power Switch to “A” or “M” while pressing down the Lock Button located on the switch.

4Set “NAVIGATION” to the desired navigation storing time. ( pg. 35, 36)

●If the “” indicator appears blinking on the screen, wait until it stops blinking. If it does not stop blinking after a while, check if a memory card is loaded.

5Press the Recording Start/Stop Button to start recording.

● When the recording time is over the navigation time set in step 5, “ ” appears briefly, then the image of the point where recording is started is captured and stored in the memory card as a thumbnail image.

●If the Recording Start/ Stop button is pressed

before “” stops

blinking, the image of the point where the loaded memory card is recognized is captured.

6Press the Recording Start/Stop Button to stop recording.