JVC KD-LH2000R Searching for a station manually Manual search, English

ENGLISH

Searching for a station manually: Manual search

1 Select the band (FM1 – 3, AM).

FM1 FM2 FM3 AM

Note:

This receiver has three FM bands (FM1, FM2, FM3). You can use any one of them to listen to an FM broadcast.

When an FM stereo broadcast is hard to receive:

1 Press MODE (M) to enter the functions mode while listening to an FM stereo broadcast. “Mode” appears on the display.

2 Press MO (monaural), while “Mode” is still on the display, so that the MO indicator is highlighted on the display.

Each time you press MO, “Mono On” and “Mono Off” alternately appears.

2 Press and hold ¢ or 4 until “Manual Search” starts flashing on the display.

3 Tune in to a station you want while “Manual Search” is flashing.

Press ¢ to tune in to stations of higher frequencies.

Press 4 to tune in to stations of lower frequencies.

•If you release your finger from the button, the manual mode will automatically turn off after 5 seconds.

•If you hold down the button, the frequency keeps changing (in 50 kHz intervals for FM and 9 kHz intervals for AM—MW/LW) until you release the button.

MONO indicator MO indicator

“STEREO” is lit when receiving an FM broadcast in stereo.

When the MONO indicator is lit on the display, the sound you hear becomes monaural but the reception will be improved.

If the sound quality decreases and the stereo effect is lost while listening to an FM station

In some areas, adjacent stations may interfere with each other. If this interference occurs, this unit can automatically reduce this interference noise (the initial setting when shipped from the factory). However, in this case, the sound quality will be degraded and the stereo effect will be also lost.

If you do not want to degrade the sound quality and to lose the stereo effect, rather than to eliminate the interference noise, see “To change the FM tuner selectivity—IF Filter” on page 38.

10