Reset button

IMPORTANT

Notice the following information will help you solve the problems. Keep this IMPORTANT sheet together with the INSTRUCTIONS book.

After installing the unit

=Follow the procedure described below.

If the unit does not operate

=Follow the procedure described below.

If a CD is not ejected from the loading slot

1“EJECT ERR” or “EJECT ERROR” appears on the display

=Follow the procedure õ described below. (If the procedure õ does not work, try the procedure .)

2No message appears on the display

=Follow the procedure described below.

If a CD is not recognized (the source does not change to the CD) even though there is a CD in the loading slot

=Follow the procedure described below. (If the procedure does not work, try the procedure .)

To reset the microcomputer

Press the reset button on the front panel using a ball-point pen or a similar tool. This will reset the built-in microcomputer.

NOTE: Your preset adjustments — such as preset channels or sound adjustments

— will also be erased.

õTo eject a CD by force

Press and hold 4 button until CD ejects.

4 button

To eject a CD by force

While holding ¢, press the reset button. Release the reset button, then release ¢. (Be careful not to drop the CD when ejecting.)

Reset button

¢ button

Page 32
Image 32
JVC KD-LX100 manual Eject ERR or Eject Error appears on the display, No message appears on the display