JVC KD-LX100 manual To turn the demo mode on or off, To select the external component to use

Turns the demo mode on. The demonstration will start automatically if no sound comes in for 3 minutes. Turns the demo mode off.

	To select the external component to use
ENGLISH
	— EXT INPUT
	You can connect the external component to the
	CD changer jack on the rear using the Line Input
	Adaptor KS-U57 (not supplied).
	To use the external component as the playback
	source through this unit, you need to select
	which component — CD changer or external
	component — to use. When shipped from the
	factory, “CHANGER” is selected as the external
	component.
	• CHANGER:	To use the CD changer.
	• LINE INPUT:	To use the external
		component other than the CD
		changer.

To make the front panel look flat (hiding the control panel) — FLAT PANEL

When operating the receiver using the remote control, you can hide the control panel to make the front panel look flat. When shipped from the

factory, “FLAT OFF” is selected.
• FLAT ON:	The control panel will not
	come out when you turn on
	the unit.
	To use the control panel,
	press 4	so that the
	control panel comes out. If no
	operation is done for about
	10 seconds, it automatically
	goes back into the receiver.
• FLAT OFF:	You can use the control panel
	normally.
Note:

When “FLAT ON” is selected, you can eject a CD by

holding 4 .

To turn the demo mode on or off

—DEMO MODE

You can turn the demo mode on or off. When shipped from the factory, “DEMO ON” is selected.

• DEMO ON:

Controlling the volume automatically (Audio Cruise)

You can select the proper cruise mode for your car.

This unit changes the volume level automatically (at 3 possible levels) based on the driving speed of your car by detecting the alternator’s generating frequency (Audio Cruise).

If you want to use this mode, follow the procedure below. When shipped from the factory, this mode is set to “CRUISE OFF.”

•CRUISE 1: Select this if your car is relatively quiet.

•CRUISE 2: Select this if your car is relatively loud.

The volume increase rate is twice as much as that of the CRUISE 1 setting.

•CRUISE OFF: Cancels Audio Cruise.

1 Press and hold SEL (Select) for more than 2 seconds so that one of the PSM items appears on the display. (See page 18.)

2 Select “CRUISE MODE.”

3 Select the desired setting.

As you turn the control dial, the Audio

Cruise mode changes as follows:

• DEMO OFF:

Note:

If the unit has been reset (and the power is on),

demonstration will start if no sound comes in for about 10 seconds.

CRUISE 1 CRUISE 2

CRUISE OFF

20