| Manual preset | |
ENGLISH | ||
You can preset up to 6 stations in each band (FM1, | ||
| ||
| FM2, FM3 and AM) manually. | |
| Ex: Storing an FM station of 88.3 MHz into the | |
| preset number 1 of the FM1 band | |
|
|
1 Select the band (FM1).
1Press SOURCE to select the tuner as the source.
2Press BAND repeatedly to select the FM1 band.
2 Tune into a station of 88.3 MHz.
Press 
¢ to tune into
stations of higher frequencies.
Press 4 
to tune into stations of lower frequencies.
3 Press and hold the number button (in this example, 1) for more than 2 seconds.
Band number and “MEMO” appear alternately for a while.
4 Repeat the above procedure to store other stations into other preset numbers.
Notes:
•A previously preset station is erased when a new station is stored in the same preset number.
•Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.
Tuning into a preset station
You can easily tune into a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on pages 9 and 10.
1 Select the band.
1Press SOURCE to select
tuner as the source.
2If necessary, press BAND repeatedly to
select the band.
Each time you press the button, the band changes as follows:
FM1
FM2 
FM3 
AM
2 Select the number (1 – 6) for the preset station you want.
When using this unit in an area other than North or South America:
You need to change the AM/FM channel intervals. See “To change the AM/FM channel intervals – AREA” on page 19.
10
