JVC KD-S790, KD-SC800 manual Manual preset

	Manual preset
ENGLISH
	You can preset up to 6 stations in each band
	(FM1, FM2, FM3, and AM) manually.
	Ex.: Storing FM station of 88.3 MHz into the
	preset number 1 of the FM1 band.
	1 Select the band (FM1 – 3, AM) you
	want to store FM stations into (in
	this example, FM1).
			Each time you press the
			button, the band changes as
			follows:
		FM1		FM2		FM3	AM
	2 Tune in to a station (in this example,
	of 88.3 MHz).
					To tune in to stations of
					higher frequencies
					To tune in to stations of
					lower frequencies

3 Press and hold the number button (in this example, 1) for more than 2 seconds.

“P1” flashes for a few seconds.

4 Repeat the above procedure to store other stations into other preset numbers.

Notes:

•A previously preset station is erased when a new station is stored in the same preset number.

•Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.

Tuning in to a preset station

You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on pages 11 and 12.

1 Select the band (FM1 – 3, AM).

Each time you press the

button, the band changes as follows:

FM1 FM2 FM3 AM

2 Select the number (1 – 6) for the preset station you want.

Note:

You can also use the 5 (up) or ∞(down) button on the unit to select the next or previous preset stations. Each time you press the 5(up) or ∞(down) button, the next or previous preset station is tuned in.

12