JVC KD-SH9750, KD-SH9700 manual Sound Adjustments, Settings, Adjust the level, DSP iEQ Fad/Bal

ENGLISH

SOUND ADJUSTMENTS

Performing the basic sound	2 Adjust the level.
settings	To adjust fader and balance—Fad, Bal:

You can set the speaker output balance, subwoofer output level, and input level of each source.

•There is a time limit in doing the following procedure. If the setting is canceled before you finish, start from step 1 again.

1 Press SEL (select) repeatedly to show one of the basic sound setting (SEL) screens.

Make these two adjustments at the same time.

•If you are using a two-speaker system, set the fader level to “00.”

• Press 5 (up) or ∞ (down) to adjust the fader.

•Press ¢ or

4 to adjust the balance.

SEL

Each time you press the button, the adjustable items change as

follows:

DSP iEQ Fad/Bal

Basic sound settings

To adjust subwoofer output—Sub Out:

This takes effect only when a subwoofer is connected.

Canceled Vol Adj Sub Out

ATT

To increase the level.

•For DSP mode settings, see pages 25 to 27.

•For iEQ (sound mode) settings, see pages 28 and 29.

Indication	To do:	Range
Fad	Adjust the front	R06 (Rear only)
	and rear speaker
	balance.	F06 (Front only)
Bal	Adjust the left	L06 (Left only)
	and right speaker
	balance.	R06 (Right only)
Sub Out	Adjust the	00 (min.)
	subwoofer output
	level and cutoff	08 (max.)
	frequency level.	Low/Mid/High
Vol Adj	Adjust and store	–05 (min.)
	the input level
	of each source.	+05 (max.)

To decrease the level.

You can also set an appropriate cutoff frequency level according to the subwoofer connected.

•Press ¢ or 4 to select “Low,” “Mid,” or “High.”

Low: Frequencies higher than 50 Hz are cut off to the subwoofer.

Mid: Frequencies higher than 80 Hz are cut off to the subwoofer.

High: Frequencies higher than 115 Hz are cut off to the subwoofer.

30