JVC KY-F1030 manual Combining with a presentation system, Mounting the lens

2. Before shooting (continued)

Combining with a presentation system

The image shot by the KY-F1030 can be passed though a scan rate converter and shown on a

D-ILA presenter or SXGA-compliant monitor.

Mounting the lens

Follow the procedure shown below when mounting a motorized lens. For further details, see the instruction manual of the lens and lens remote control.

		AA-P700
Connect the power supply		AC ADAPTER AA-P700
		POWER
( page E18)
		ON
			AC
		OFF
		AC adapter	[VIDEO IN]
	[ANALOG OUT]
[DC IN]

4.	[MD
Camera head
Thread section
Mount clamp ring
Lens
2.

		CAUTION
CONTROL] connector	•	Perform mounting of the lens
3. Lock		with the power of the camera
		turned OFF. Mounting with the
		power on could result in dam-
		age.
	•	Lens is not included with this
(Female)	4. Lock	unit.

FOCUS LOCK

Mount the lens (
page E17)

D-ILA or SXGA-compliant monitor

	JVC KM-F700
[VIDEO INPUT]
terminal	Scan rate converter

1.Connect the KY-F1030’s [ANALOG OUT] connector to the scan rate converter’s [VIDEO INPUT] terminal.

2.Connect the AC adapter (AA-P700) to the KY-F1030, and then turn ON the power.

3.Turn ON the other devices.

*Also see the instructions for the scan rate converter to be used.

MEMO

•When connected to the PC through the [IEEE1394] connector, or an RS-232C device is connected to the [REMOTE] terminal, the auto white balance function of the scan rate converter will be disabled.

•When the shutter speed becomes slower (slower than 1/7.5s), the image may be seen interrupted.

•The image will not freeze even when the scan rate converter’s [FREEZE] button is pressed.

•The scan rate converter’s [SEND] command is invalid.

	Lens remote control
	Compatible lens	Lens remote controller
Compatible	remote controller
zoom lens	FJINON, RMD-10,
D16⋅7.3A-D29	RMD-20

1.	Remove the lens mount cap. At this time, take caution so that dust do not enter inside the
	mount.
2.	To mount the lens, lightly press the thread section of the lens mount onto the thread section
	of KY-F1030, then turn the lens unit or KY-F1030 slowly clockwise until it is securely tight-
	ened.
	MEMO
To change the position of the lens rotation:

￿First, turn the mount clamp ring clockwise (1/4 turns) with the lens facing you.

￿Slowly turn the lens and after adjusting the position, retighten the mount clamp ring.

3.	Insert the camera cable of the lens into the [LENS] connection terminal on the rear of KY-
	F1030, then securely lock.
	The iris control is made from the KY-F1030.
4.	When using the lens remote controller, connect the lens control cable (female) to the re-
	mote control. Also, when focusing and zoom controller is to be performed on the KY-F1030,
	connect the lens control cable (female) to the [MD CONTROL] terminal on the KY-F1030.
	When operating the lens iris manually by lens remote control connection, set IRIS MODE to
	manual. ( page E33)
	CAUTION
When using a motorized lens, use the AC adapter as power supply for the KY-F1030.
If power is supplied via the [IEEE1394] connector, control of the motorized lens is not possible from the
KY-F1030.

E16 E17