![](/images/new-backgrounds/1262134/26213425x1.webp)
2. Before shooting (continued) Fall prevention
Fall prevention wire chain
Mounting screw dimen- sions: • When mounted on top: 10 mm • When mounted on un- derside: 6 mm
3. Settings and adjustments for shooting | ||||||||
Lens settings |
| |||||||
Set according to whether the used lens to be used is an | ||||||||
|
|
|
|
|
|
| Set the used Lens |
|
|
|
|
|
|
|
| Set the [IRIS MODE] on the [EXPOSURE] screen. | |
|
|
|
|
|
|
| ( page E33) | |
|
|
|
|
|
|
| AUTO | : Setting when |
|
|
|
|
|
|
| MANUAL : Set when using a manual lens, using an | |
|
|
|
|
|
| |||
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| lens in MANUAL or no lens. |
*If the
(Default setting: AUTO) Monitor adjustment
The colour contrast and brightness are adjusted whilst,
MEMO
•Special attention is required when mounting the unit to the wall or ceiling. Rather than attempting to do it yourself, request a qualified person to perform such instal- lation. Falling of the unit may result in bodily injury.
•To prevent the unit from falling, connect the unit to a strong surface with a wire chain, etc. When connecting such chain, use the bracket locking screw hole on the side which the camera mounting bracket is not mounted.
•When mounted on top: M 2.6 ⋅ 10 mm (provided)
•When mounted on underside: M 2.6 ⋅ 6 mm
Take special caution to the length of the optional wire as well.
•For the
[ANALOG OUT] | [IEEE1394] |
ANALOG OUT | IEEE1394 |
| |
LENS |
|
| MD |
| CONTROL |
DC IN | REMOTE |
POWER |
|
SEE INSTRUCTION MANUAL |
Inside window | |
| UP/AW |
MENU | SET |
| DOWN |
1 2 | 3 4 |
Default Setting Switch |
1. | Connect the [ANALOG OUT] connector or the | ||||
| [IEEE1394] connector to the PC. | ||||
2. | Set the function setting switch NO.1 on the switch panel | ||||
| on the side of the | ||||
| ON |
|
|
|
|
|
|
|
|
| |
| OFF | 2 | 3 | 4 | |
| 1 | ||||
3. | Turn ON the |
*When connecting through the [IEEE1394] connector, power is supplied from the PC.
4. | Adjust the monitor. |
| MEMO |
•For how to adjust, see the instructions for the employed monitor.
•The peak level of the test signal is set to 0.7V from the fac- tory. To use 0.57V, change the setting by [TEST PATTERN] ➝ [LEVEL] on the [SYSTEM SETTING] screen.
page E40 TEST PATTERN
E20 | E21 |
|