Getting started

English

Français

To connect to an amplifier/receiver equipped with Dolby Digital 5.1-channel inputs

The Dolby Digital decoder is built in the unit, so you can enjoy the Dolby digital surround sound without the need of an external decoder.

Connect the unit’s 5.1-channel outputs to the Dolby Digital 5.1-channel inputs of an amplifier or receiver using the supplied audio cables.

 

 

 

The unit

 

VIDEO OUT

 

 

VIDEO

S-VIDEO Y

PB

PR

AV COMPU LINK

 

 

 

 

 

 

COMPONENT

 

 

FRONT

REAR

CENTER

 

 

LEFT

 

 

PCM/STREAM

 

 

 

 

COAXIAL

 

 

 

AUDIO

DIGITAL

 

 

 

 

Red

White

 

Red

White

Yellow

Red

 

White

 

Audio cable (supplied)

White

Red

White

Yellow Red White

Red

Amplifier or receiver

CENTER

SUBWOOFER

FRONT

AUDIO IN

LEFT

RIGHT

REAR

LEFT

RIGHT

Getting started

Audio/video cable (supplied)

Audio cable (supplied)

Be sure to connect correctly between corresponding terminals. The order of the 5.1-channel terminals depend on units.

An Audio/video cable is recommended for connection to the FRONT terminal (Yellow jack (for Video Signal) is not used in this connection).

NOTE

¦When using the 5.1-channel outputs of the unit, set the "DOWN MIX" in the "PREFERENCE 2" on-screen display to "OFF" and select "5.1 CHANNEL" or "EXPERT" in the "SPK.SETTING" on-screen display. If the "EXPERT" is selected, you can control the audio output balance of the speakers (see pages 57 and 60).

19

Page 23
Image 23
JVC LET0141-002A manual Center Subwoofer Front