Adjusting the surround sound | JVC LET0141-002A specification

Basic Operations

Adjusting the surround sound

English

Français

You can select the simulated surround effect depending on the disc contents. If you connect the unit to your stereo system, you can enhance sound quality and produce a greater surround effect.

To simulate the surround sound [3D PHONIC]

7During playback

1 Press 3D PHONIC .

2 Within 10 seconds, select the desired effect mode by pressing 3D PHONIC .

Each time you press , the

3D PHONIC

effect mode changes as follows:

ACTION*

DRAMA

THEATER

3D PHONIC
THEATER L	H
Selected effect mode	Basic operations
	Basic operations

OFF

*When you play the DVD disc recorded in Dolby Digital and contains more than 3 channel sound, ACTION does not appears.

To erase the 3D PHONIC screen, press ENTER . The 3D PHONIC screen disappears if there are no operations for more than 10 seconds.

3 Press to adjust the effect level.

You can adjust the effect level in 5 steps.

Toward L : Reduce the effect

Toward H : Enhance the effect

3D PHONIC
THEATER	L	H

Effect level

NOTES

¦The sound effect (3D PHONIC) is possible only on discs which are recorded in DOLBY SURROUND or DOLBY DIGITAL. However, some DOLBY SURROUND or DOLBY DIGITAL discs do not contain the rear sound signal, in this case, the setting can be changed but the sound effect cannot be obtained.

¦You can change the setting of the discs which do not contain the rear sound signal, but the sound effect cannot be obtained.

¦The sound effect is not possible, and will not work even if set when the unit outputs the DTS or Dolby Digital bitstream signal from the DIGITAL OUT jack.

¦The sound effect will not be set or operate, even if 3D PHONIC is pressed, on the sound of DVD discs recorded in Linear PCM.

¦When you set the 3D PHONIC function to on, the DOWN MIX and COMPRESSION setting in the PREFERENCE 2 display and settings in the SPK.SETTING are disabled.

33

Image 37

JVC LET0141-002A Adjusting the surround sound, To simulate the surround sound 3D Phonic, Press to adjust the effect level

Contents

XV-D701BK Mises en garde, précautions et indications diverses Introduction Table of contents Checking the total disc time Playing a scene close-up Features Changing the language and sound Using the instructions Power cord Installation of the unitAvoid high temperatures When you’re away Preliminary knowledge Front panel Names of parts and controls Rear panel Display window Remote control unit Cancel button Audio Volume buttonCATV/SAT Power button DVD/TV/CATV switch 24 Display information Preference 1 and 2 and Speaker setting displays seeOn-screen displays Basic operations in on-screen display DVD on-screen display during playback Parental Lock on-screen display seeVideo CD on-screen display during playback On-screen guide icons To prevent the monitor from burning outAbout invalid operation icon Playable disc types Preliminary knowledge about discsPlayable discs Non-playable discs Example audio CD/video CD Track Disc construction Getting started Before making any connections ConnectionsYellow Video Red White Connect Y to Y, PB to PB, PR to PR Connection to an audio amplifier or receiver To connect to an audio amplifier or receiverUnit Red White Audio cable Supplied Amplifier or receiver Center Subwoofer Front White To connect to audio equipment with a digital input Turn on the unit To connect the power cord Precautions for the safe use of batteries To install batteries in the remote control unitPrecaution To turn on/off the unit Power To use the remote control unit for TV operation Using the remote control unitManufacturer code list Changing the remote control signal Set DVD Catv on the remote control unit to Catv Manufacturer’s code listPress and hold Power Then press SET Do not release Keep holding Power Getting started Basic operations Press Power to turn on the unit Press Power to turn on your TVBefore operation To turn on your TV and the unit To insert or remove discs Inserting and removing discsPress Close to close the disc tray Information about the opening display To playback a disc from the beginning Playing back a DVD Video or CD discTo stop playback completely Press Stop To advance or reverse play rapidly while monitoring To stop playback temporarilyTo locate the beginning of the scene or song Press Pause Resuming playback 7During stop modePress Resume Unit starts playback from the stored position Press to adjust the effect level Adjusting the surround soundSelected effect mode To simulate the surround sound 3D Phonic Summary of basic operations How to use numeric buttonsPress Numeric buttons are used to select a track or title number To playback a scene close-up Zoom To adjust the picture quality VFPTo select a scene angle from the angle list display To select the subtitle language Subtitle To locate the desired scene from the menu Playing a specific scene on a DVD discPress Use to select the desired item, then press Enter Use 1 to 10 , +10 to select the desired title number When is displayed in the TV screenUnit begins playback from the selected title Title you have selected is not contained in the disc When is displayed in the TV screen in step When the chapter number is incorrect in stepTo return to the regular display To locate the desired scene by specifying the time When appears in the TV screen in step When you make a mistake in step7The unit starts playback from the selected time Use To select When you want to check moreDesired title To display still pictures Strobe Playing in slow-motionTo playback in slow-motion Slow Press Pause , then press SLOW+ To playback a scene close-up Zoom Playing a scene close-upPress Zoom Use to move the zoomed-in scene To repeat a title or chapter Repeat Repeat playbackUse to move to REPEAT, then press Enter To repeat a desired part A-B Repeat To cancel A-B repeat playback To select a scene angle from the on-screen display Angle Viewing from multiple anglesPress Angle Press Angle or to select the desired angle Use to move to Angle Press and hold Angle for more than 1 seconds When appears on the TV screen in stepUse to select desired angle Press Enter Selected angle appears on the TV screen To select the subtitle language Subtitle Changing the language and soundUse to move to Subtitle To select the desired Use to select desired audio language or sound Use to move AudioTotal number Selected audio number To adjust the picture quality VFP Adjusting the picture to suit preferencesPress VFP or Processor on the front panel By pressing VFP or on the front panel Setting and adjustment Press to select the setting you want Move to select the item you want to set by usingSelecting preferences Press Stop to stop the unit Preference 1 can be set as follows To set the language and display preference itemsSelected language Japanese = language code from AA to Selected languageSpanish French On Screen Guide Preference 2 can be set as follows To set other preference itemsPlayback discs Output L0/R0 Lt/RtAudio is played back as it was recorded Picture is scrolled ModePicture is not scrolled Picture gets dark Auto standby function is off AV Compulink Mode When you connect to a 2-channel amplifier, or use 2 speakers Speaker setting Bass redirect available only when selecting Expert Speaker size available only when selecting ExpertWoofer Delay available only when selecting Expert Speaker level available only when selecting ExpertTo exit the speaker level or delay setting mode Woofer sub-woofer Select Test Tone using Then press Test tone available only while setting Level or DelayTo exit the test tone mode Color of Test Tone changes To set Parental Lock for the first time Parental Lock Limiting playback by childrenPress Enter while holding down Stop Use to select the CA for country code and press New setting is effective To change the settings Parental LockUse to move to Set Level, then use to select the parental lock level If you select YES, moves to the Password field Enter your 4-digit password using 0 toWhen selecting NO, press Close button to remove the disc To temporarily release the Parental lock Parental Lock To playback only the beginning of each track Intro To select the time display mode Time Select Select a desired track number using To locate a desired track using Next or PreviousPlaying a specific track on a disc To locate a desired track directly Use 0 to 9 to select To locate a desired position by specifying the timeTime minute and second then press Enter Use to move to Time Search and press When you make a mistake in step To playback in the desired order Program Changing the track orderPress Play to start program play To playback tracks in random order Random Unit can play tracks in random order 7During stop modeUse to move to Random Color of Random changes Random play begins To quit repeat playback To repeat a current track or all tracks Repeat Press Enter at the end Use to move to A-BPart you want to repeat point B Use to move to Intro Sampling all tracksColor of Intro changes To stop Intro scan Use To move To select the time display mode Time Select Information about CD Text What is CD TEXT? Audio CD operations Video CD operations To use the menu of the Video CD recorded on PBC Playing a specific scene on a Video CDUse Desired number of the item To locate a disired track directly During playback without the PBC function or stop modeDuring playback without the PBC function Use to move to Time Search and press Time search function does not work during PBC playback Use to select the desired track When you want to check more Scenes, press . AdditionalUnit begins playback from the selected track Unit play the slowest speed, and each time you press Press Zoom To cancel zoom play You can program tracks during playback 7Random play begins Unit can play tracks in random order 7During stopTo stop random play Press Stop 7During playback without PBC function Use to move to Repeat To cancel A-B repeat To stop Intro scan Press Stop To playback only the beginning of each track Intro Selected of the picture quality tab lights up in yellow By pressing VFP or Processor on Front panel To change the audio channel Audio Select the audio channels to be played back usingSelected audio channel Use to move to Time Select Checking the total disc timePress Enter until Total Remain appears on the TV screen Total disc time appears on the TV screen Connection and setup Care and handling of discs Troubleshooting Maintenance of discs How to handle discsCare and handling of discs Even on label side Symptom Possible case Remedy Troubleshooting Connection and Setup AV Compu Link remote control system Operation Specifications Appendix a Table of languages and their abbreviations Appendix B Country code list for parental lock Page EN. FR 0299TTMUBNPRI