JVC HR-DVS3EK Installing Satellite Controller, Situate the Satellite Controller, Make connections

SAT CONTROL SET 17

Satellite Receiver Control Setting

Satellite receiver

Your recorder	Satellite Controller
	(suggested locations)
Transmitter	Satellite Controller
	(provided)

Satellite receiver

21-pin SCART cable

(provided)

SAT CONTROL

Back of recorder

AV2 (L-2) IN/DECODER

The following procedure is required if you receive satellite channels through a satellite receiver. Approximately 20 seconds before the VIDEO Plus+ timer programming ( pg. 36) or Express timer programming ( pg. 38) starts, the recorder sets its input mode to “L-2” and automatically switches the satellite receiver’s channels using the provided Satellite Controller.

Installing Satellite Controller

A Situate the Satellite Controller.

Place the Satellite Controller so that the path between its transmitter and the satellite receiver’s remote sensor is unobstructed.

B Attach the Satellite Controller.

Fix securely using the adhesive strip attached on the back of the Satellite Controller.

C Make connections.

Be sure to connect the recorder’s AV2 (L-2) IN/DECODER connector to the satellite receiver’s 21-pin SCART connector.

NOTE:

When connecting your satellite receiver, refer to its instruction manual.

D Connect the Satellite Controller to recorder.

Connect the Satellite Controller to the SAT CONTROL connector on the rear panel.